Effects of sintering temperature on the structural and electrochemical properties of SrFe0.5Ti0.5O3-δperovskite cathode-Reference-Cited by-同舟云学术

Effects of sintering temperature on the structural and electrochemical properties of SrFe0.5Ti0.5O3-δperovskite cathode

Published:2017-11-06 Issue:2 Volume:15 Page:338-348
ISSN:1546-542X
Container-title:International Journal of Applied Ceramic Technology
language:en
Short-container-title:Int J Appl Ceram Technol

Author:

Baharuddin Nurul Akidah¹^ORCID,Muchtar Andanastuti¹²^ORCID,Somalu Mahendra Rao¹,Anwar Mustafa¹³,Shaikh Abdul Kader Abdul Hameed Muhammed Ali¹,Mah Joelle¹

Affiliation:

1. Fuel Cell Institute; Universiti Kebangsaan Malaysia; Bangi Malaysia

2. Department of Mechanical and Materials Engineering; Faculty of Engineering and Built Environment; Universiti Kebangsaan Malaysia; Bangi Malaysia

3. U.S Pakistan Center for Advanced Studies in Energy; National University of Sciences and Technology; Islamabad Pakistan

Funder

Ministry of Higher Education, Malaysia

Universiti Kebangsaan Malaysia

Publisher

Wiley

Subject

Materials Chemistry,Marketing,Condensed Matter Physics,Ceramics and Composites

Link

http://onlinelibrary.wiley.com/wol1/doi/10.1111/ijac.12825/fullpdf

Reference59 articles.

1. Strength of an electrolyte supported solid oxide fuel cell;Fleischhauer;J Power Sources,2015

2. Effects of Various Co-Dopants and Carbonates on the Properties of Doped Ceria-Based Electrolytes : a Brief Review Electrolytes for SOFCs;Anwar;Int J Appl Eng Res,2016

3. Materials for solid oxide fuel cells;Jacobson;Chem Mater,2010

4. Challenges in fabricating planar solid oxide fuel cells: a review;Mahmud;Renew Sustain Energy Rev,2017

5. Development of lanthanum strontium cobalt ferrite composite cathodes for intermediate- to low-temperature solid oxide fuel cells;Baharuddin;J Zhejiang Univ Sci A,2013

Cited by 15 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. A review on the application of magnetron sputtering technologies for solid oxide fuel cell in reduction of the operating temperature;International Journal of Hydrogen Energy;2024-01

2. Influence of sintering temperature on the properties of the screen-printed anode of the LSMO4 Ruddlesden‒Popper perovskite for intermediate-temperature solid oxide fuel cells;International Journal of Hydrogen Energy;2023-12

3. High temperature coefficient of resistivity (TCR) of Nd0.67Sr0.33MnO3 films by optimizing sintering temperature;Applied Surface Science;2023-12

4. Recent Advances in Perovskite Ceramics: Synthesis, Processing, and Applications;Advanced Ceramics;2023-11-11

5. Understanding the Impact of Sintering Temperature on the Properties of Ni–BCZY Composite Anode for Protonic Ceramic Fuel Cell Application;Processes;2023-06-24