New solid particle seeding generator for laser-based velocity measurements in reacting flows-Reference-Cited by-同舟云学术

New solid particle seeding generator for laser-based velocity measurements in reacting flows

Published:2019-03-01 Issue:1 Volume:43 Page:63-68
ISSN:0315-8977
Container-title:Transactions of the Canadian Society for Mechanical Engineering
language:en
Short-container-title:Transactions of the Canadian Society for Mechanical Engineering

Author:

Saediamiri Meghdad¹²,Birouk Madjid¹²

Affiliation:

1. Department of Mechanical Engineering, University of Manitoba, 75A Chancellors Circle, Winnipeg, MB R3T 5V6, Canada

2. Department of Mechanical Engineering, University of Manitoba, 75A Chancellors Circle, Winnipeg, MB R3T 5V6, Canada.

Abstract

The design of a new solid particle seeding generator for laser-based velocity measurements in gaseous flows is reported. Performance tests revealed that the new seeder has the ability to control the concentration of seeding particles in a flow independently of the flowrate. It also can provide a steady supply of seeding particles, operate over an extended range of flowrate, and break up agglomerates into smaller particles. These features give this seeder advantages over its counterparts, especially at low volumetric flowrate.

Publisher

Canadian Science Publishing

Subject

Mechanical Engineering

Link

http://www.nrcresearchpress.com/doi/pdf/10.1139/tcsme-2017-0058

Reference9 articles.

1. Dantec Dynamics. 2014. DynamicStudio — user’s guide. Dantec Dynamics A/S, Denmark.

2. Iyogun, C.O. 2009. Effect of nozzle geometry on the stability of a turbulent jet flame with and without swirling co-flow. Ph.D. thesis, University of Manitoba, Winnipeg, MB, Canada.

3. Experimental investigation of the effect of fuel nozzle geometry on the stability of a swirling non-premixed methane flame

4. Tracer particles and seeding for particle image velocimetry

5. A Generic Centerline Velocity Decay Curve for Initially Turbulent Axisymmetric Jets