Effect of diaphragms on stress reduction in box girder bridge sections

Abstract

The purpose of this study is to examine the effect of rigid diaphragms in reducing warping and distortion stresses developed in box girders due to deformation of the cross section. Tests were conducted for two Plexiglas box girder models to determine effect of diaphragms on the behaviour of box girder sections. The results of the tests were compared with values obtained from the so-called “beam on elastic foundation (BEF) analogy,” an analytical procedure that permits the calculation of warping and distortion stresses in box sections due to deformation of the cross section.Each box girder model was tested as a simply supported beam with a 1168.4 mm (46 in.) span. Six separate loading positions were used for each of the three predesigned diaphragm spacings. Thus, 18 separate loading tests were conducted for each model in order to obtain sufficient data to determine the amount of reduction in both warping and distortion stresses. Test measurements included the applied load, deflections, and strains at various locations on the webs and bottom flanges.The results indicate that deformation of a box girder cross section due to eccentric loading may cause substantial warping and distortion stresses, and that these stresses can be effectively controlled by judicious installation of rigid diaphragms along the span of the girder. Also, experimental warping and distortion stresses obtained from both tests compare reasonably well with those predicted by the BEF analogy. Key words: warping, torsional, stresses, deformations, box girder bridges, diaphragms.