Dynamic analysis of laterally loaded pile groups in sand and clay

Abstract

Pile foundations supporting bridge piers, offshore platforms, and marine structures are required to resist not only static loading but also lateral dynamic loading. The static p–y curves are widely used to relate pile deflections to nonlinear soil reactions. The p-multiplier concept is used to account for the group effect by relating the load transfer curves of a pile in a group to the load transfer curves of a single pile. Some studies have examined the validity of the p-multiplier concept for the static and cyclic loading cases. However, the concept of the p-multiplier has not yet been considered for the dynamic loading case, and hence it is undertaken in the current study. An analysis of the dynamic lateral response of pile groups is described. The proposed analysis incorporates the static p–y curve approach and the plane strain assumptions to represent the soil reactions within the framework of a Winkler model. The model accounts for the nonlinear behaviour of the soil, the energy dissipation through the soil, and the pile group effect. The model was validated by analyzing the response of pile groups subjected to lateral Statnamic loading and comparing the results with field measured values. An intensive parametric study was performed employing the proposed analysis, and the results were used to establish dynamic soil reactions for single piles and pile groups for different types of sand and clay under harmonic loading with varying frequencies applied at the pile head. "Dynamic" p-multipliers were established to relate the dynamic load transfer curves of a pile in a group to the dynamic load transfer curves for a single pile. The dynamic p-multipliers were found to vary with the spacing between piles, soil type, peak amplitude of loading, and the angle between the line connecting any two piles and the direction of loading. The study indicated the effect of pile material and geometry, pile installation method, and pile head conditions on the p-multipliers. The calculated p-multipliers compared well with p-multipliers back-calculated from full scale field tests.Key words: lateral, transient loading, nonlinear, pile–soil–pile interaction, p–y curves, Statnamic.