Abstract
Abstract
It could be argued today that oil companies would be better described as water companies. Total worldwide oil production averages some 75 million barrels per day and, while estimates vary, this is associated with the production of 300–400 million barrels of water per day. These values of approximately 5–6 barrels of water for every barrel of oil are quite conservative. In the United States, where many fields are depleted, the ratio of water-to-oil production is closer to 9 to 1. In some areas around the world, fields remain on production when the ratio is as high as 50 to 1.
Water production is a harbinger of problems in an oil well. It can cause scaling problems in susceptible wells, induce fines migration or sandface failure, increase corrosion of tubulars, and kill wells by hydrostatic loading, amongst other things. Thus, while water production is an inevitable consequence of oil production, it is usually desirable to defer its onset, or its rise, for as long as possible.
Numerous strategies, both mechanical and chemical, have been employed over the years in attempts to achieve this. Simple shut-off techniques, using cement, mechanical plugs and cross-linked gels have been widely used. Exotic concepts, like relative permeability modification (RPM), have also been applied with varying degrees of success.
This paper is a continuation of a previous one, which reviewed the traditional techniques and proposed some new methodologies and technologies that can be used in the design of RPM treatments, in particular1. Additional new insights offered in this paper include the extension of matrix RPM treatments to more extreme well conditions, such as heavy (viscous) oil and low pH environments. It also introduces the concept and reviews several case histories of the usage of RPM systems to perform hydraulic fracturing treatments to simultaneously stimulate oil and control water. This conformance-fracture technique could significantly impact the development strategies of many fields worldwide.
Introduction
Water cuts in oil producing wells are increasing as time passes and oil fields become mature. The source of the water is either formation water or injected water used for reservoir pressure maintenance purposes. In addition, heterogeneities encountered in reservoirs rocks can cause water channeling through higher permeability streaks/hairline fractures and/or near-wellbore water coning at early times in the well's productive life, usually due to limited reservoir thickness or excessive pressure drawdowns. Whatever the scenario, the cause is always associated with a higher mobility of water relative to oil. Usually, the lower the API gravity of the oil, the greater the chance of water production, since low-gravity oils are typically much more viscous and, hence, have lower mobility. However, mobility is not the only factor. Additional wettability effects caused by heavy oil deposition, produced by pressure and temperature cycles in the near wellbore area, can compound the problem.