A Study of DME-Steam Co-Injection Using a Large-Scale Physical Model-Reference-Cited by-同舟云学术

A Study of DME-Steam Co-Injection Using a Large-Scale Physical Model

Published:2024-03-12 Issue: Volume: Page:
ISSN:
Container-title:Day 2 Thu, March 14, 2024
language:
Short-container-title:

Author:

Amer H.¹,Sheng K.¹,Okuno R.¹,Filstein A.²,French M.²,Sanchez J.³,Al-Gawfi A.⁴,Nakutnyy P.⁴

Affiliation:

1. Hildebrand Department of Petroleum and Geosystems Engineering, University of Texas at Austin, Austin, Texas, USA

2. ConocoPhillips, Calgary, Alberta, Canada

3. ConocoPhillips, Doha, Qatar

4. Saskatchewan Research Council, Regina, Saskatchewan, Canada

Abstract

Abstract Dimethyl ether (DME) as a water-soluble solvent has been studied as a potential additive to steam for improving the energy efficiency of steam-assisted gravity drainage (SAGD). The main objective of this research was to study in-situ flow characteristics and energy efficiency of DME-SAGD using a large-scale physical model. Results from DME-SAGD were compared with the control experiment of SAGD with no solvent injection using the same experimental setup. The main novelty of this research lies in the experimental data that demonstrated enhanced bitumen drainage by DME-SAGD in comparison to SAGD. The experiment was conducted in a cylindrical pressure vessel with a diameter of 0.425 m and a length of 1.22 m, which contained a sand pack with a porosity of 0.34 and a permeability of 5.0 D. The DME-SAGD experiment used a DME concentration of 10 mol% and a steam co-injection rate of 27.6 cm3/min [cold-water equivalent (CWE)] at 3000 kPa. Temperature distributions within the sand pack, along with injection and production histories, were recorded during the experiment. Subsequently, numerical simulations were performed to history-match the experimental data, and the calibrated simulation model was used to analyze details of compositional flow characteristics. Results showed that the 10 mol% DME-SAGD experiment yielded a recovery factor of 92.7% in 4.2 days, and the SAGD experiment yielded a recovery factor of 68.6% in 6.0 days, for both of which the first 2 days were the preheating and the steam-only injection (SAGD) stages. The peak rate of bitumen production was 43.8 mL/min in the DME-SAGD experiment, which was more than twice greater than the peak rates observed in the SAGD experiment. The substantially increased rate of bitumen production resulted in a cumulative steam-to-oil ratio in DME-SAGD that was less than half of that in SAGD. Analysis of experimental results indicated that the solubility of DME in the aqueous and oleic phases caused different flow characteristics between DME-SAGD and SAGD. For example, the oleic and aqueous phases were more uniformly distributed in the sand pack in the former. Simulations indicated that DME-SAGD had a uniform distribution of greater grid-scale Bond numbers and increased oleic-phase mobilities in comparison to SAGD.

Publisher

SPE

Link

https://onepetro.org/specet/proceedings-pdf/doi/10.2118/218077-MS/3374417/spe-218077-ms.pdf

Reference48 articles.

1. Amer, H., Sheng, K., Okuno, R. 2024a. A Systematic Comparison Of Solvents And Their Concentrations In Bitumen Gravity Drainage Under Controlled Thermodynamic Conditions. Fuel357 (A): p. 129723. https://doi.org/10.1016/j.fuel.2023.129723.

2. Amer, H., Sheng, K., Okuno, R. 2024b. Gravity Drainage Of Bitumen Under Controlled Thermodynamic Conditions In DME-Steam Co-Injection. Geoenergy Science and Engineering233: p. 212539. https://doi.org/10.1016/j.geoen.2023.212539.

3. Baek K. H. , ShengK., Arguelles-VivasF. J. 2019. Comparative Study Of Oil-Dilution Capability Of Dimethyl Ether And Hexane As Steam Additives For Steam-Assisted Gravity Drainage. SPE Res Eval & Eng22(3): 1030–48. SPE-187182-PA. https://doi.org/10.2118/187182-PA.

4. Bentsen, R. G. and Manai, A. A. 1993. On The Use Of Conventional Cocurrent And Countercurrent Effective Permeabilities To Estimate The Four Generalized Permeability Coefficients Which Arise In Coupled, Two-Phase Flow. Transport Porous Media11 (3): 243–262. https://doi.org/10.1007/BF00614814.

5. Bourbiaux, B. J. and Kalaydjian, F. J. 1990. Experimental Study of Cocurrent and Countercurrent Flows in Natural Porous Media. SPE Res Eval & Eng5 (3): 361–368. SPE-18283-PA. https://doi.org/10.2118/18283-PA.