Affiliation:
1. Emitec Technologies
2. Southwest Research Institute
3. Eaton
Abstract
<div class="section abstract"><div class="htmlview paragraph">Engine and aftertreatment solutions have been identified to meet the upcoming ultra-low NO<sub>x</sub> regulations on heavy duty vehicles in the United States. These standards will require changes to current conventional aftertreatment systems for dealing with low exhaust temperature scenarios while increasing the useful life of the engine and aftertreatment system. Previous studies have shown feasibility of meeting the US EPA and California Air Resource Board (CARB) requirements. This work includes a 15L diesel engine equipped with cylinder deactivation (CDA) and an aftertreatment system that was fully DAAAC aged to 800,000 miles. The aftertreatment system includes an e-heater (electric heater), light-off Selective Catalytic Reduction (LO-SCR) followed by a primary aftertreatment system containing a DPF and SCR. The e-heater was capable of providing up to 10 kW, however for the purpose of this project, lower power settings of 2.5 kW and 5 kW were studied in combination with CDA for lowest possible CO2 emissions. Test cycles included the heavy duty FPT (hot and cold), a low load cycle, a beverage cycle, and a stay hot operation. The data found in this study show how the application of a low power e-heater enables an engine with CDA and an aftertreatment system after 800,000 miles aging to meet ultra-low NO<sub>x</sub> emissions with minimum CO<sub>2</sub> penalty.</div></div>
Reference19 articles.
1. Kasab , J.J. ,
Hadl , K. ,
Raser , B. ,
Sacher , T.
et al.
Close-Coupled SCR - An Approach to Meet Ultra-Low NOx Requirements for Heavy-Duty Diesel Engines 2021 CLEERS Virtual Workshop
2. Webb , C. ,
Stephenson , P. ,
Meijer , M. ,
Coumans , A.
et al.
Future Regulatory Technology Options to Reduce Risk in Application for Heavy Duty Diesel Engines Aachen Colloquium Sustainable Mobility 2021 2021
3. Matheaus , A. ,
Neely , G.A. ,
Sharp , C.A. ,
Hopkins , J.
et al.
Fast Diesel Aftertreatment Heat-up Using CDA and an Electrical Heater SAE Technical Paper 2021-01-0211 2021 https://doi.org/10.4271/2021-01-0211
4. Zavala , B. ,
McCarthy , J. Jr. ,
Matheaus , A. , and
Sharp , C.
Fast Diesel Aftertreatment Heat-Up Using CDA and an Electrical Heater between 1.2 and 5.0 kW Frontiers in Mechanical Engineering 2022
5. Meruva , P. ,
Matheaus , A. ,
Sharp , C.A. ,
McCarthy , J.E. Jr.
et al.
Meeting Future NOx Emissions Using an Electric Heater in an Advanced Aftertreatment System Frontiers in Mechanical Engineering 2022 10.3389/fmech.2022.979771 2