Over 250 W low noise core-pumped single-frequency all-fiber amplifier

Abstract

A high-power linearly-polarized all-fiber single-frequency amplifier at 1 µm based on tandem core-pumping is demonstrated by using a large-mode-area Ytterbium-doped fiber with a core diameter of 20 µm, which nicely balances the stimulated Brillouin scattering effect, thermal load, and output beam quality. A maximum output power of more than 250 W with a corresponding slope efficiency of >85% is achieved at the operating wavelength of 1064 nm without being constrained by the saturation and nonlinear effects. Meanwhile, a comparable amplification performance is realized with a lower injection signal power of the wavelength near the peak gain of the Yb-doped fiber. The polarization extinction ratio and the M2 factor of the amplifier are respectively measured to be >17 dB and 1.15 under the maximal output power. In addition, by virtue of the single-mode 1018 nm pump laser, the intensity noise of the amplifier under maximal output power is measured to be comparable to that of the single-frequency seed laser at frequencies higher than 2 kHz, except for the emergence of parasitic peaks that can be eliminated by optimizing the driving electronics of the pump lasers, while the deterioration of the amplification process to the frequency noise and linewidth of the laser is negligible. To the best of our knowledge, this is the highest output power of a single-frequency all-fiber amplifier based on the core-pumping scheme.