High heat flux testing of a HIP bonded first wall panel with built-in circular cooling tubes-Reference-Cited by-同舟云学术

High heat flux testing of a HIP bonded first wall panel with built-in circular cooling tubes

Published:1998-09 Issue: Volume:39-40 Page:363-370
ISSN:0920-3796
Container-title:Fusion Engineering and Design
language:en
Short-container-title:Fusion Engineering and Design

Author:

Hatano T,Suzuki S,Yokoyama K,Suzuki T,Tokami I,Kitamura K,Kuroda T,Akiba M,Takatsu H

Publisher

Elsevier BV

Subject

Mechanical Engineering,General Materials Science,Nuclear Energy and Engineering,Civil and Structural Engineering

Reference9 articles.

1. IAEA, Technical Basis for the ITER Interim Design Report, Cost Review and Safety Analysis, ITER EDA Documentation Series, No 7, 1996.

2. Design of the ITER EDA plasma facing components;Cardella;Fusion Eng. Des.,1998

3. S. Sato, et al., Fabrication of HIPped first wall structure for fusion experimental reactor and preliminary analysis for its thermomechanical test, Proceedings of the Sixteenth IEEE/NPSS Symposium on Fusion Engineering, Champaign, 1995, p. 1343.

4. K. Furuya, et al., Fabrication of Small-scaled Shielding Blanket Module and First Wall Panel for International Thermonuclear Experimental Reactors, Proceedings of the Nineteenth Symposium on Fusion Technology, Lisbon, 1996, p. 202.

5. ABAQUS USER’S MANUAL, Ver. 5.4, Hibbitt, Karlson and Sorenssen, Incorporated, 1995.

Cited by 20 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Determining the shear fracture properties of HIP joints of reduced-activation ferritic/martensitic steel by a torsion test;Journal of Nuclear Materials;2012-08

2. Assessment of thermo-mechanical behavior in CLAM steel first wall structures;Fusion Engineering and Design;2012-01

3. Effect of HIP temperature on microstructure and low cycle fatigue strength of CuCrZr alloy;Journal of Nuclear Materials;2011-10

4. Torsion test technique for interfacial shear evaluation of F82H RAFM HIP-joints;Fusion Engineering and Design;2011-10

5. Thermo-Mechanical Analysis of CLAM Steel and SS316L in the First Wall for ITER;Materials Science Forum;2011-02