Damage tolerant design by microstructural gradation – Influence of processing parameters and build orientation on crack growth within additively processed 316L-Reference-Cited by-同舟云学术

Damage tolerant design by microstructural gradation – Influence of processing parameters and build orientation on crack growth within additively processed 316L

Published:2019-09 Issue: Volume:764 Page:138186
ISSN:0921-5093
Container-title:Materials Science and Engineering: A
language:en
Short-container-title:Materials Science and Engineering: A

Author:

Brenne F.,Niendorf T.

Funder

Deutsche Forschungsgemeinschaft

Publisher

Elsevier BV

Subject

Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science

Reference60 articles.

1. Wohlers Report 2015 - 3D Printing and Additive Manufacturing State of the Industry;Wohlers,2015

2. Additive layered manufacturing: sectors of industrial application shown through case studies;Petrovic;Int. J. Prod. Res.,2011

3. Metal additive manufacturing: a review;Frazier;J. Mater. Eng. Perform.,2014

4. Additive manufacturing of metallic components – process, structure and properties;DebRoy;Prog. Mater. Sci.,2018

5. Microstructure and mechanical behavior of Ti-6Al-4V produced by rapid-layer manufacturing, for biomedical applications;Murr;J. Mech. Behav. Biomed. Mater.,2009

Cited by 26 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Interpenetrating microstructure in laser powder-bed fusion parts using selective rescanning;Additive Manufacturing Letters;2024-07

2. A multi-scale experimental investigation on fatigue crack propagation rate behavior of powder bed fusion-laser beam 316L stainless steel subjected to various heat treatments;Engineering Fracture Mechanics;2024-05

3. Experimental investigation of process parameter variations on the microstructure and failure behavior of IN718 structures in PBF-LB/M;Journal of Laser Applications;2024-01-02

4. Crack propagation and strain-induced α’-martensite transformation in selective laser melting 316L stainless steels;Frontiers in Materials;2023-09-19

5. Micromechanical modeling of the low-cycle fatigue behavior of additively manufactured AlSi10Mg;Materials Science and Engineering: A;2023-07