Investigation of porosity, texture, and deformation behavior using high energy X-rays during in-situ tensile loading in additively manufactured 316L stainless steel-Reference-Cited by-同舟云学术

Investigation of porosity, texture, and deformation behavior using high energy X-rays during in-situ tensile loading in additively manufactured 316L stainless steel

Published:2021-04 Issue: Volume:810 Page:141034
ISSN:0921-5093
Container-title:Materials Science and Engineering: A
language:en
Short-container-title:Materials Science and Engineering: A

Author:

Murphy-Leonard Aeriel D.,Pagan Darren C.,Callahan Patrick G.,Heinkel Zach K.,Jasien Christopher E.^ORCID,Rowenhorst David J.^ORCID

Funder

Office of Naval Research

Publisher

Elsevier BV

Subject

Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science

Reference69 articles.

1. Microstructure and mechanical behavior of Ti-6Al-4V produced by rapid-layer manufacturing, for biomedical applications;Murr;J. Mech. Behav. Biomed. Mater.,2009

2. The influence of annealing temperature and time on the formation of δ-phase in additively-manufactured inconel 625;Stoudt;Metall. Mater. Trans. A Phys. Metall. Mater. Sci.,2018

3. F.H. Kim, S.P. Moylan, S.P. Moylan, NIST Advanced Manufacturing Series 100-16 Literature Review of Metal Additive Manufacturing Defects NIST Advanced Manufacturing Series 100-16 Literature Review of Metal Additive Manufacturing Defects, ((n.d.)).

4. The deformation, recrystallisation and texture of three magnesium alloy extrusions;Mackenzie;Mater. Sci. Technol.,2007

5. Grain Structure Control of Additively Manufactured;Yan,2017

Cited by 22 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Creep-fatigue properties and deformation mechanism of 316L steel fabricated by laser powder bed fusion (PBF-LB/M);Materials Science and Engineering: A;2024-09

2. Surface heterostructuring of 316L stainless steel manufactured by laser powder bed fusion and hot isostatic pressing;Materials Science and Engineering: A;2024-09

3. In-situ thermal control-assisted laser directed energy deposition of curved-surface thin-walled parts;Additive Manufacturing;2024-03

4. Time lapse in situ X-ray imaging of failure in structural materials under cyclic loads and extreme environments;Journal of Materials Science & Technology;2024-03

5. Enhancing mechanical properties and electrochemical behavior of equiatomic FeNiCoCr high-entropy alloy through sintering and hot isostatic pressing for binder jet 3D printing;Additive Manufacturing;2024-02