Using thermally insulated polymer film for mold temperature control to improve surface quality of microcellular injection molded parts-Reference-Cited by-同舟云学术

Using thermally insulated polymer film for mold temperature control to improve surface quality of microcellular injection molded parts

Published:2008-10 Issue:8 Volume:35 Page:991-994
ISSN:0735-1933
Container-title:International Communications in Heat and Mass Transfer
language:en
Short-container-title:International Communications in Heat and Mass Transfer

Author:

Chen Hui-Li,Chien Rean-Der,Chen Shia-Chung

Publisher

Elsevier BV

Subject

Condensed Matter Physics,General Chemical Engineering,Atomic and Molecular Physics, and Optics

Reference16 articles.

1. The production and analysis of microcellular thermoplastic foam;Martini,1982

2. F.A. Waldman, The Processing of Microcellular Foam, S.M. Thesis, Department of Mechanical Engineering, Massachusetts Institute of Technology: Cambridge, MA, 1982.

3. Gas dissolution and crystallization in microcellular thermoplastic polyesters;Baldwin,1992

4. Rapid heating for microcellular nucleation in a polymer melt;Park,1993

5. An extrusion system for the processing of microcellular polymer sheets: shaping and cell growth control;Baldwin;Polym. Eng. Sci.,1996

Cited by 41 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Effect of inorganic nanoparticles on polypropylene in‐mold decoration and microcellular foaming injection molding composites;Polymer Engineering & Science;2024-07-25

2. Development of a modular mold with a carbon nanotube web film heater for rapid-heating cycle molding;The International Journal of Advanced Manufacturing Technology;2024-03-14

3. Morphology and properties of PC/ABS notebook computer shell prepared by a combined in-mold decoration and microcellular injection molding process;Journal of Cellular Plastics;2024-02-20

4. Visualization Analysis of Wrinkle Generation Phenomenon in PP Decorative Sheets (Part 2) ―Identification of Interfacial Thermal Resistance by Measurement of Temperature Change inside Decorative PP Sheets and at Flow Front―;Seikei-Kakou;2023-12-20

5. Weld Line Strength of Polyamide Fiberglass Composite at Different Processing Parameters in Injection Molding Technique;Polymers;2023-10-16