Using differential mold temperatures to improve the residual wall thickness uniformity around curved sections of fluid assisted injection molded tubes-Reference-Cited by-同舟云学术

Using differential mold temperatures to improve the residual wall thickness uniformity around curved sections of fluid assisted injection molded tubes

Published:2009-05 Issue:5 Volume:36 Page:491-497
ISSN:0735-1933
Container-title:International Communications in Heat and Mass Transfer
language:en
Short-container-title:International Communications in Heat and Mass Transfer

Author:

Lin Kun-Yeh,Chang Fu-An,Liu Shih-Jung

Publisher

Elsevier BV

Subject

Condensed Matter Physics,General Chemical Engineering,Atomic and Molecular Physics, and Optics

Reference9 articles.

1. Gas injection molding of an automotive structural part;Shah;Plastics Engineering,1991

2. Computer-aided engineering for gas-assisted injection molding;Turng;Plastics Engineering,1993

3. Water injection—it's all coming together;Knights;Plastic Technology,2005

4. Water injection technique (WIT);Michaeli,2009

5. Study on the residual wall thickness at dimensional transitions and curved sections in gas-assisted molded circular tubes;Yang;Polymer Engineer and Science,2004

Cited by 19 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Experimental analysis of fluid‐assisted injection molding of pipe fittings with different angles by short‐shot method;Engineering Reports;2022-09-14

2. The sensitivity of the behavior of water penetrating polypropylene matrix composites on short‐shot process parameters;Polymer Engineering & Science;2022-07-09

3. Influence of Heat Sink on the Mold Temperature of Gypsum Mold Used in Injection Molding;Polymers;2020-03-21

4. Optimization of Residual Wall Thickness Uniformity in Short-Fiber-Reinforced Composites Water-Assisted Injection Molding Using Response Surface Methodology and Artificial Neural Network-Genetic Algorithm;Advances in Polymer Technology;2020-02-26

5. Overview of the Experimental Trends in Water-Assisted Injection Molding;Macromolecular Materials and Engineering;2018-06-04