Achieving highly promising strength-ductility synergy of powder bed fusion additively manufactured titanium alloy components at ultra-low temperatures-Reference-Cited by-同舟云学术

Achieving highly promising strength-ductility synergy of powder bed fusion additively manufactured titanium alloy components at ultra-low temperatures

Published:2023-03 Issue: Volume:65 Page:103444
ISSN:2214-8604
Container-title:Additive Manufacturing
language:en
Short-container-title:Additive Manufacturing

Author:

Zang M.C.,Niu H.Z.,Liu S.,Guo R.Q.,Zhang D.L.

Publisher

Elsevier BV

Subject

Industrial and Manufacturing Engineering,Engineering (miscellaneous),General Materials Science,Biomedical Engineering

Reference44 articles.

1. Liquid hydrogen fuel system design and demonstration in a small long endurance air vehicle;Stroman;Int. J. Hydrog. Energy,2014

2. Liquid hydrogen fuel tanks for commercial aviation: structural sizing and stress analysis;Gomez;Aerosp. Sci. Technol.,2019

3. Investigation on the deformation mechanism of Ti–5Al–2.5Sn ELI titanium alloy at cryogenic and room temperatures;Lu;Mater. Sci. Eng. A,2021

4. Study of microstructure, mechanical properties and residual stresses in full penetration electron beam welded Ti–5Al–2.5Sn alloy sheet;Junaid;Mater. Des.,2018

5. On the characteristics of titanium alloys for the aircraft applications;Singh;Mater. Today,2017

Cited by 8 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Anomalous strain rate dependence of ultra-low temperature strength and ductility of an electron beam additively manufactured near alpha titanium alloy;Journal of Materials Science & Technology;2024-11

2. Microstructural evolution and cryogenic and ambient temperature deformation behavior of the near-α titanium alloy TA15 fabricated by laser powder bed fusion;Journal of Alloys and Compounds;2024-10

3. Surface damage of metastable β Ti55531 alloy with bimodal microstructure induced by friction and wear;Engineering Failure Analysis;2024-09

4. Achieving superior strength-ductility combination in the heterogeneous microstructured Ti64 alloy via multi-eutectoid elements alloying with CoCrFeNiMn during laser powder bed fusion;Virtual and Physical Prototyping;2024-07-12

5. A review of the use of cryogenic coolant during machining titanium alloys;Sustainable Materials and Technologies;2024-07