Accuracy of complex internal channels produced by laser powder bed fusion process-Reference-Cited by-同舟云学术

Accuracy of complex internal channels produced by laser powder bed fusion process

Published:2020-06 Issue: Volume:54 Page:48-53
ISSN:1526-6125
Container-title:Journal of Manufacturing Processes
language:en
Short-container-title:Journal of Manufacturing Processes

Author:

Calignano Flaviana^ORCID,Peverini Oscar Antonio,Addamo Giuseppe,Iuliano Luca

Publisher

Elsevier BV

Subject

Industrial and Manufacturing Engineering,Management Science and Operations Research,Strategy and Management

Reference32 articles.

1. Additive manufacturing: a key enabling technology for next-generation microwave and millimeter-wave systems [point of view];Sorrentino;Proc. IEEE,2016

2. Design of microwave waveguide devices for space and ground application implemented by additive manufacturing;Montejo-Garai;Proc. 2015 Int. Conf. Electromagn. Adv. Appl. ICEAA 2015,2015

3. Additive manufacturing of low cost and efficient proof of concepts for microwave passive components;Laplanche;IET Microwaves, Antennas Propag,2017

4. Applications of layer-by-layer polymer stereolithography for three-dimensional high-frequency components;Liu;IEEE Trans Microw Theory Tech,2004

5. 3D printed waveguide slot array antennas;Le Sage;IEEE Access,2016

Cited by 21 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Enhancement of acoustic cavitation streaming: A study on surface finishing of additively manufactured components;CIRP Journal of Manufacturing Science and Technology;2024-10

2. Computer-Aided Design and Additive Manufacturing for Automotive Prototypes: A Review;Applied Sciences;2024-08-15

3. Residual Stress Mapping in Heat-Assisted Additive Manufacturing of IN 718: An X-Ray Diffraction Study;Journal of Materials Engineering and Performance;2024-03-05

4. Effective Spiral Laser Path for Minimizing Local Heating and Anisotropic Microstructures in Powder Bed Fusion Additive Manufacturing;3D Printing and Additive Manufacturing;2023-12-22

5. Influence of the aspect ratio of an additive manufacturing component on the surface roughness during cutting with wire EDM;International Journal on Interactive Design and Manufacturing (IJIDeM);2023-12-13