Performance of a Chemical Heat Blanket in Dry, Damp, and Wet Conditions Inside a Mountain Rescue Hypothermia Wrap

Abstract

Introduction Casualties with accidental hypothermia are evacuated using multilayer wraps, typically including a chemical heat blanket (CHB), a vapor barrier, and an insulating outer bag. We investigated CHB performance against dry, damp, and wet fabric, in a multilayer wrap, in response to a case report indicating diminished performance when wet. Methods We wrapped a torso manikin in a base layer, CHB, vapor barrier, casualty bag, and vacuum mattress, recording CHB panel temperatures at intervals of up to 7 h. Experimental conditions were dry, damp, and wet clothing, with 2 blankets tested in each condition. We subsequently used a forward-looking infrared camera to assess whether the panels heated evenly and heat flux sensors to quantify heat transfer across 2 dry, 1 damp, and 1 wet fleece under CHB panels. Results Chemical heat blankets maintained heat output for >7 h inside the wraps. Median (IQR) panel steady state temperatures were 52°C (39–56°C) against dry fleece, 41°C (36–45°C) against damp fleece, and 30°C (29–33°C) against wet fleece. Peak panel temperature was 67°C. The heat flux results indicated that CHBs generated similar quantities of heat in dry and damp conditions, as the lower temperatures were compensated by more efficient transfer of heat across the moist clothing layer. Chemical heat blanket heat output was diminished in wet conditions. Conclusions Rescuers should cut off saturated clothing in a protected environment before wrapping casualties, but damp clothing need not be removed. Because of the high peak temperatures recorded on the surfaces of CHBs, they should not be placed directly against skin, and compression straps should not be placed directly over CHBs.