Statistical analysis of surface roughness and cutting forces using response surface methodology in hard turning of AISI 52100 bearing steel with CBN tool-Reference-Cited by-同舟云学术

Statistical analysis of surface roughness and cutting forces using response surface methodology in hard turning of AISI 52100 bearing steel with CBN tool

Published:2010-05 Issue:3 Volume:28 Page:349-361
ISSN:0263-4368
Container-title:International Journal of Refractory Metals and Hard Materials
language:en
Short-container-title:International Journal of Refractory Metals and Hard Materials

Author:

Bouacha Khaider,Yallese Mohamed Athmane,Mabrouki Tarek,Rigal Jean-François

Publisher

Elsevier BV

Subject

General Medicine

Reference18 articles.

1. CBN tool wear in hard turning: a survey on research progresses;Huang;Int J Adv Manuf Technol,2006

2. PCBN tool wear modes and mechanisms in finish hard turning;Lahiff;Robot Comput Integr Manuf,2007

3. Hard machining of hardened bearing steel using cubic boron nitride tool;Yallese;J Mater Process Technol,2009

4. Estimation of cutting forces and surface roughness for hard turning using neural networks;Sharma;J Intell Manuf,2008

5. Machining characteristics of hard materials;Nakayama;Ann CIRP,1988

Cited by 294 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Enhancement of machinability and surface tribological property of hardened bearing steel by electric pulse-assisted hard turning;Tribology International;2024-11

2. Manufacturing process optimization for real-time quality control in multi-regime conditions: Tire tread production use case;Journal of Manufacturing Systems;2024-10

3. Finite element analysis of residual stress and optimization of machining parameters in turning of annealed AISI 1040 Steel;International Journal on Interactive Design and Manufacturing (IJIDeM);2024-08-17

4. Multi-objective Optimization of Process Parameters for Surface Quality and Geometric Tolerances of AlSi10Mg Samples Produced by Additive Manufacturing Method Using Taguchi-Based Gray Relational Analysis;Arabian Journal for Science and Engineering;2024-08-05

5. Effect of hBN and SDS added vegetable based cutting fluid application on the performance of turning Ti6Al4V alloys: A Comparative analysis with Taguchi and ANN approaches;Materials Chemistry and Physics;2024-08