The Exit Failure of Cemented Carbide Face Milling Cutters Part II —s Testing of Commercial Cutters-Reference-Cited by-同舟云学术

The Exit Failure of Cemented Carbide Face Milling Cutters Part II —s Testing of Commercial Cutters

Published:1984 Issue:1 Volume:33 Page:51-54
ISSN:0007-8506
Container-title:CIRP Annals
language:en
Short-container-title:CIRP Annals

Author:

van Luttervelt C.A.,Willemse H.R.,Pekelharing A.J.

Publisher

Elsevier BV

Subject

Industrial and Manufacturing Engineering,Mechanical Engineering

Reference7 articles.

1. F.L. Lucca, An Investigation on the transient effects in interrupted cutting by simulated machining. Masters thesis Rensselaer Polytechnic Institute Troy, New York - May 1982.

2. L.J. Dammer Ein Beitrag zur Prozessanalyse und Schnittwertvorgabe beim Messerkopfstirnfräsen Doctor Thesis - TH Aachen 1982.

3. L.J. Dammer, P. Gras, Austritt bedingungen beim Stirnfräsen-Ursache für Schneldenausbrüche. Industrie Anzeiger Nr. 88 (1981) 103Jg pp 21-24.

Cited by 13 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Influence of micro-geometry of wiper facet on the performance of a milling insert: an experimental investigation and validation using numerical simulation;Sādhanā;2022-07-12

2. Surface Roughness Analysis of Magnesium Pieces Obtained by Intermittent Turning;Materials Science Forum;2013-11

3. Cutter Exit Effects during Milling of Thin-Walled Inconel 718;Advanced Materials Research;2012-11

4. Burr minimization in face milling: an edge bevelling approach;Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture;2011-09

5. Turning of titanium alloy with TiB2-coated carbides under cryogenic cooling;Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture;2003-12-01