Development of divertor plate with CFCs bonded onto DSCu cooling tube for fusion reactor application-Reference-Cited by-同舟云学术

Development of divertor plate with CFCs bonded onto DSCu cooling tube for fusion reactor application

Published:1998-10 Issue: Volume:258-263 Page:318-322
ISSN:0022-3115
Container-title:Journal of Nuclear Materials
language:en
Short-container-title:Journal of Nuclear Materials

Author:

Suzuki S.,Suzuki T.,Araki M.,Nakamura K.,Akiba M.

Publisher

Elsevier BV

Subject

Nuclear Energy and Engineering,General Materials Science,Nuclear and High Energy Physics

Reference14 articles.

1. Technical basis for the ITER interim design report, cost review and safety analysis, ITER EDA documentation series, No. 7, International Atomic Energy Agency, Vienna, 1996

2. S. Suzuki, M. Akiba, M. Araki, M. Seki, H. Ise, Y. Ozawa, N. Tachikawa, M. Toyoda, S. Yamazaki, Development of divertor modules for fusion experimental reactors, Proceedings of the Second Japan International SAMPE Symposium, 1991, pp. 1176–1182

3. M. Araki, M. Akiba, M. Dairaku, K. Iida, H. Ise, M. Seki, S. Suzuki, K. Yokoyama, Thermal response of bonded CFC/OFHC divertor mock-ups for fusion experimental reactors under large numbers of cyclic high heat loads, J. Nucl. Sci. and Tech. 29 (9) 901–908

4. S. Suzuki, M. Araki, K. Sato, K. Masaki, K. Nakamura, M. Akiba, T Ando, K. Yokoyama, M. Dairaku, Y. Ohara, Development of the divertor plate at JAERI, Proceedings of the 18th Symposium on Fusion Technology, Fusion Technology, 1994, pp. 311–314

5. M. Onozuka, M. Toyoda, S. Tsujimura, M. Inoue, M. Satoh, Development of actively cooled divertor plates for fusion experimental devices, Proceedings of the 18th Symposium on Fusion Technology, Fusion Technology, 1994, pp. 315–318

Cited by 9 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Key achievements in elementary R&D on water-cooled solid breeder blanket for ITER test blanket module in JAERI;Nuclear Fusion;2006-01-16

2. Proposal of hot-pressed, rod-shaped tungsten armor concept for ITER divertor and its high-heat-flux performances;J NUCL SCI TECHNOL;2005

3. Proposal of Hot-pressed, Rod-shaped Tungsten Armor Concept for ITER Divertor and its High-heat-flux Performances;Journal of Nuclear Science and Technology;2005-07

4. Development of ITER Divertor Vertical Target with Annular Flow Concept—II: Development of Brazing Technique for CFC/CuCrZr Joint and Heating Test of Large-Scale Mock-Up;Fusion Science and Technology;2004-12

5. Finite element analysis and simulation of adhesive bonding, soldering and brazing an addendum: a bibliography (1996 2002);Modelling and Simulation in Materials Science and Engineering;2002-09-04