Fabrication and mechanical properties of steel–steel composites-Reference-Cited by-同舟云学术

Fabrication and mechanical properties of steel–steel composites

Published:2001-02 Issue:1-2 Volume:300 Page:135-141
ISSN:0921-5093
Container-title:Materials Science and Engineering: A
language:en
Short-container-title:Materials Science and Engineering: A

Author:

Sun Shoujin,Pugh Martin

Publisher

Elsevier BV

Subject

Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science

Reference9 articles.

1. Influence of ferrite-martensite microstructural morphology on tensile properties of dual-phase steel

2. Microstructure-mechanical property relationships of dual-phase steel wire

3. Heat treating of steel, ASM Metals Handbook, vol. 4. American Society for Metals, Metals Park, OH, 1991, p. 78.

4. S. Sun, Directionally structured dual phase steel composites, Ph.D. thesis, Mechanical Engineering, University of Canterbury, Christchurch, New Zealand, 1998.

5. An Introduction to Composite Materials;Hull,1996

Cited by 4 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Gradient alternating deformation mechanism of two metals and interface bonding mechanism of cu/Al cold rolling composite process;Materials Characterization;2023-07

2. The effect of surface preparation on the bond strength of Al-St strips in CRB process;Materials & Design;2016-10

3. Study on Hot-Working Behavior of High Carbon Steel / Low Carbon Steel Composite Material Using Processing Map;Key Engineering Materials;2014-09

4. Investigation of the tensile properties of continuous steel wire-reinforced gray cast iron composite;Materials Science and Engineering: A;2011-04