Analysis of effective parameters for stress intensity factors in the contact problem between an asymmetric wedge and a half-plane using an experimental method of photoelasticity-Reference-Cited by-同舟云学术

Analysis of effective parameters for stress intensity factors in the contact problem between an asymmetric wedge and a half-plane using an experimental method of photoelasticity

Published:2013-01 Issue: Volume:43 Page:447-453
ISSN:0261-3069
Container-title:Materials & Design
language:en
Short-container-title:Materials & Design

Author:

Khaleghian Seyedmeysam,Emami Anahita,Tehrani Mehran,Soltani Nasser

Publisher

Elsevier BV

Subject

Applied Mathematics,General Mathematics

Reference33 articles.

1. A fracture mechanics life prediction methodology applied to dovetail fretting;Golden;Tribol Int,2006

2. Application of fracture mechanics to estimate fretting fatigue endurance curves;Munoz;Eng Fract Mech,2007

3. Contact mechanics;Barber;Int J Solids Struct,2000

4. Self-similar problems of elastic contact for non-convex punches;Borodich;J Mech Phys Solids,2002

5. Contact mechanics for randomly rough surfaces;Persson;Surf Sci Rep,2006

Cited by 19 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. On the removing contact problem of a Brazilian disc using inclined brackets: an experimental approach using reflection photoelasticity;Archive of Applied Mechanics;2023-11-03

2. Experimental evaluation of J-integral in elastic and elastic–plastic polymers by means of digital image correlation and higher-order eigenfields under mode-I;Engineering Fracture Mechanics;2023-10

3. Experimental Characterization of Frictional Line Contact by Digital Image Correlation and Inverse Method;Journal of Engineering Mechanics;2021-11

4. Experimental investigation of additively manufactured continuous fiber reinforced composite parts with optimized topology and fiber paths;Additive Manufacturing;2021-08

5. Investigating the hot isostatic pressing of an additively manufactured continuous carbon fiber reinforced PEEK composite;Additive Manufacturing;2021-01