The influence of sintering temperature and pressure on microstructure and mechanical properties of carbonyl iron powder materials fabricated by electric current activated sintering-Reference-Cited by-同舟云学术

The influence of sintering temperature and pressure on microstructure and mechanical properties of carbonyl iron powder materials fabricated by electric current activated sintering

Published:2017-03 Issue: Volume:137 Page:137-147
ISSN:0042-207X
Container-title:Vacuum
language:en
Short-container-title:Vacuum

Author:

Ye Yongquan,Li Xiaoqiang,Cheng Zhun,Zhang Minai,Qu Shengguan

Funder

National Nature Science Foundation of China

Fundamental Research Funds

Nature Science Foundation of Guangdong Province, China

Technology Special Project of Guangdong Province

Open Foundation of National Engineering Research Center of Near-Net-Shape Forming for Metallic Materials

Innovation and Strong School Project of Guangzhou Maritime University

Guangzhou Technology Special Project

Publisher

Elsevier BV

Subject

Surfaces, Coatings and Films,Condensed Matter Physics,Instrumentation

Reference29 articles.

1. Crystallization kinetics and spark plasma sintering of amorphous Ni53Nb20Ti10Zr8Co6Ta3 powders prepared by mechanical alloying;Li;Vacuum,2015

2. Spark-plasma sintering of W-5.6 Ni-1.4 Fe heavy alloys: densification and grain growth;Hu;Metall. Mater. Trans. A,2013

3. Transmitting, emitting and controlling light: processing of transparent ceramics using current-activated pressure-assisted densification;Kodera;Scr. Mater,2013

4. Mechanical behaviors of porous Ti with high porosity and large pore size prepared by one-step spark plasma sintering technique;Zhang;Vacuum,2015

5. Continuous in situ functionally graded silicon nitride materials;Belmonte;Acta Mater,2009

Cited by 8 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Impact of Mg doping on the structural, morphological and dielectric properties of PbTiO3 ceramics synthesized by consecutive combination of sol–gel and hydrothermal methods at low temperature;Journal of Materials Science: Materials in Electronics;2024-02

2. Sintering of nanocrystalline materials: Sintering parameters;Heliyon;2023-03

3. Influence of sintering pressure on microstructure and tribological properties of Copper–Tin composites containing graphite and MoS₂;Surface Topography: Metrology and Properties;2022-11-15

4. Effect of holding time and pressure on the densification, microstructure and mechanical properties of hot pressed Al2O3-CA6-ZrO2/Ni multi-phase composites;Journal of Alloys and Compounds;2021-01

5. Effect of laser re-melting on electric current assistive sintered CoCrFeNiAlxTiy high entropy alloys: Formation, micro-hardness and wear behaviors;Surface and Coatings Technology;2020-10