1. E. Bociąga, T. Jaruga, K.L., A. Gnatowski, Warpage of injection moulded parts as the result of mould temperature difference. Arch. Mater. Sci. Eng. 2010, 44.
2. Warpage analysis and optimization of thin-walled injection molding parts based on numerical simulation and orthogonal experiment;Chen;IOP Conf. Series: Mater. Sci. Eng.,2019
3. D. Kusić, A. Hančič, Influence of molding conditions on the shrinkage and warpage behavior of standardized test specimens, 2016. DOI: 10.1063/1.4965468.
4. Investigation of cooling effect at corners in injection molding;Kovács;Int. Commun. Heat Mass Transfer,2011
5. P. Alves, Shrinkage and warpage behaviour on injection moulding parts, 2008.