Optimization of surface roughness, cutting force and tool wear of nitrogen alloyed duplex stainless steel in a dry turning process using Taguchi method-Reference-Cited by-同舟云学术

Optimization of surface roughness, cutting force and tool wear of nitrogen alloyed duplex stainless steel in a dry turning process using Taguchi method

Published:2014-03 Issue: Volume:49 Page:205-215
ISSN:0263-2241
Container-title:Measurement
language:en
Short-container-title:Measurement

Author:

Philip Selvaraj D.,Chandramohan P.,Mohanraj M.

Publisher

Elsevier BV

Subject

Applied Mathematics,Electrical and Electronic Engineering,Condensed Matter Physics,Instrumentation

Reference34 articles.

1. ASM Specialty Handbook Stainless Steels;Davis,1996

2. Reduce costs for storage and distribution of desalted water – use duplex stainless steel;Snis;Desalination,2008

3. Duplex – a new generation of stainless steels for desalination plants;Snis;Desalination,2007

4. A study of the machining of cast austenitic stainless steel with carbide tools;Agrawal;J. Mater. Process. Technol.,1995

5. Tool wear and machinability of X5 CrMnN 18 8 stainless steels;Paro;J. Mater. Process. Technol.,2001

Cited by 188 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Force modeling and experimental investigations on machinability of SDSS 2507 under dry turning conditions using CVD TiCN-Al2O3 coated tools;Sādhanā;2024-08-14

2. Multi-objective Optimization of Process Parameters for Surface Quality and Geometric Tolerances of AlSi10Mg Samples Produced by Additive Manufacturing Method Using Taguchi-Based Gray Relational Analysis;Arabian Journal for Science and Engineering;2024-08-05

3. Optimization of the Surface Roughness and Chip Compression Ratio of Duplex Stainless Steel in a Wet Turning Process Using the Taguchi Method;Machines;2024-06-26

4. Multi-response optimization of charcoal briquettes process for green economy using a novel TOPSIS linear programming and genetic algorithms based on response surface methodology;Results in Engineering;2024-06

5. Investigation on machining of GFRP through ANOVA, DFA, and CoCoSo method combined with Taguchi approach;Journal of Reinforced Plastics and Composites;2024-03-22