The use of modeling to understand malfunction and failure in mechanical seals-Reference-Cited by-同舟云学术

The use of modeling to understand malfunction and failure in mechanical seals

Published:2003-12 Issue:12 Volume:2003 Page:8-12
ISSN:1350-4789
Container-title:Sealing Technology
language:en
Short-container-title:Sealing Technology

Author:

Salant Richard F.

Publisher

Mark Allen Group

Subject

Mechanical Engineering,General Chemical Engineering

Reference13 articles.

1. Metcalfe, R. (1973) Performance analysis of axisymmetric flat face mechanical seals. In Proceedings of the Sixth International Conference on Fluid Sealing, paper D1, BHRA.

2. Non-axisymmetric incompressible hydrostatic pressure effects in radial face seals;Etsion;ASME Journal of Lubrication Technology,1978

3. Lebeck, A.O. (1977) A study of mixed lubrication in contacting mechanical face seals. In Proceedings of the Fourth Leeds–Lyon Symposium on Tribology, Mechanical Engineering Publications Ltd.

4. Development of an analytical model for use in mechanical seal design;Salant,1984

5. Improved mechanical seal design through mathematical modeling;Salant,1984

Cited by 7 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Wear Simulation Method for Mechanical Seals Under Mixed Lubrication Using Flow Factors;Proceedings of the 7th International Conference on Fracture Fatigue and Wear;2018-07-15

2. A microscale mesh numerical method for simulating tribological characteristics of sealing materials;International Journal for Numerical Methods in Engineering;2016-03-28

3. Experimental investigation on frictional behavior and sealing performance of different composites for seal application;Wear;2015-11

4. Analytical and experimental study on the sliding contact of the sealing ring in the wet clutch;Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering;2015-01-16

5. Multiscale simulation of sliding contacts between two rough sealing surfaces;Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology;2013-10-25