Heat treatment induced microstructural evolution, oxidation behavior and tribological properties of Fe-12Cr-9Ni-2Al steel (CX steel) prepared using selective laser melting-Reference-Cited by-同舟云学术

Heat treatment induced microstructural evolution, oxidation behavior and tribological properties of Fe-12Cr-9Ni-2Al steel (CX steel) prepared using selective laser melting

Published:2022-01 Issue: Volume:429 Page:127982
ISSN:0257-8972
Container-title:Surface and Coatings Technology
language:en
Short-container-title:Surface and Coatings Technology

Author:

Chang Cheng,Yan Xingchen,Deng Zhaoyang,Lu Bingwen,Bolot Rodolphe,Gardan Julien,Deng Sihao,Chemkhi Mahdi,Liu Min,Liao Hanlin

Publisher

Elsevier BV

Subject

Materials Chemistry,Surfaces, Coatings and Films,Surfaces and Interfaces,Condensed Matter Physics,General Chemistry

Reference34 articles.

1. Effect of heat treatment on the phase transformation and mechanical properties of Ti6Al4V fabricated by selective laser melting;Yan;J. Alloys Compd.,2018

2. Additive manufacturing of WC reinforced maraging steel 300 composites by cold spraying and selective laser melting;Yan;Surf. Coat. Technol.,2019

3. Microstructure characteristics of inconel 625 superalloy manufactured by selective laser melting;Li;J. Mater. Sci. Technol.,2015

4. Selective laser melting technique of co-cr dental alloys: a review of structure and properties and comparative analysis with other available techniques;Koutsoukis;J. Prosthodont.,2015

5. Fatigue strength improvement of selective laser melted Ti6Al4V using ultrasonic surface mechanical attrition;Yan;Mater. Res. Lett.,2019

Cited by 25 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Eliminating metallurgical defects and achieving strength-ductility combination in selective laser melted martensitic stainless steel through high-pressure annealing;Materials Characterization;2024-10

2. Role of heat treatment conditions in the high-temperature deformation behavior of laser-powder bed fused Fe–Cr–Ni–Al maraging stainless steel;Materials Science and Engineering: A;2024-09

3. Augmenting microstructure and tribological performance of wire arc additive manufactured PH13-8Mo stainless steel via TiC/TiB2 nano-particles incorporation;Journal of Materials Research and Technology;2024-09

4. Additive Manufacturing of PH 13-8 Mo Family: A Review;Applied Sciences;2024-08-27

5. Influence of Microdefect on Mechanical Behaviors of CX Stainless Steel Produced by Selective Laser Melting;Metals and Materials International;2024-08-16