Ti surface modification by cold spraying with TiO 2 microparticles-Reference-Cited by-同舟云学术

Ti surface modification by cold spraying with TiO 2 microparticles

Published:2017-01 Issue: Volume:309 Page:749-758
ISSN:0257-8972
Container-title:Surface and Coatings Technology
language:en
Short-container-title:Surface and Coatings Technology

Author:

Schmidt Kilian,Buhl Sebastian,Davoudi Neda,Godard Claudia,Merz Rolf,Raid Indek,Kerscher Eberhard,Kopnarski Michael,Müller-Renno Christine,Ripperger Siegfried,Seewig Jörg,Ziegler Christiane,Antonyuk Sergiy

Funder

DFG Collaborative Research Center 926

Publisher

Elsevier BV

Subject

Materials Chemistry,Surfaces, Coatings and Films,Surfaces and Interfaces,Condensed Matter Physics,General Chemistry

Reference28 articles.

1. Cold Spray Technology;Papyrin,2007

2. Computational analysis of the interfacial bonding between feed-powder particles and the substrate in the cold-gas dynamic-spray process;Grujicic;Appl. Surf. Sci.,2003

3. Interface behavior of particles upon impacting during cold spraying of Cu/Ni/Al mixture;Li;Mater. Des.,2016

4. Surface structuring by a cold spray technique to modify friction and wear properties of case hardened chain pins;Buhl;Particuology,2015

5. Osteoblast adhesion on biomaterials;Anselme;Biomaterials,2000

Cited by 33 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Coating of Refractory Surfaces with Fine TiO2 Particles via Gas-Dynamic Cold Spraying;Coatings;2024-09-07

2. Structure and photocatalytic properties of the composite coating fabricated by detonation sprayed Ti powders;Ceramics International;2024-01

3. Deposition and fabrication of biomaterials using cold spray technique: A review on the application of biomedical-implants;Applied Surface Science Advances;2023-12

4. Numerical simulation of cold-sprayed hydroxyapatite coating on 316L stainless steel;Finite Elements in Analysis and Design;2023-11

5. Microstructuring of Component Surfaces with Fine Particles by Cold Spraying;Lecture Notes in Civil Engineering;2023-10-25