Effect of chip sliding velocity and temperature on the wear behaviour of PVD AlCrN and AlTiN coated mixed alumina cutting tools during turning of hardened steel-Reference-Cited by-同舟云学术

Effect of chip sliding velocity and temperature on the wear behaviour of PVD AlCrN and AlTiN coated mixed alumina cutting tools during turning of hardened steel

Published:2018-01 Issue: Volume:334 Page:509-525
ISSN:0257-8972
Container-title:Surface and Coatings Technology
language:en
Short-container-title:Surface and Coatings Technology

Author:

Kumar Ch. Sateesh^ORCID,Patel Saroj Kumar

Publisher

Elsevier BV

Subject

Materials Chemistry,Surfaces, Coatings and Films,Surfaces and Interfaces,Condensed Matter Physics,General Chemistry

Reference35 articles.

1. Cutting temperatures during hard turning—measurements and effects on white layer formation in AISI 52100;Hosseini;J. Mater. Process. Technol.,2014

2. Cutting of hardened steel;Tönshoff;CIRP Ann. Manuf. Technol.,2000

3. Surface & coatings technology experimental and numerical investigations on the effect of varying AlTiN coating thickness on hard machining performance of Al2O3-TiCN mixed ceramic inserts;Kumar;Surf. Coat. Technol.,2017

4. Performance of mixed ceramics and CBN tools during hard turning of martensitic stainless steel;Sobiyi;Int. J. Adv. Manuf. Technol.,2015

5. Tribological properties of the PVD and CVD coatings deposited onto the nitride tool ceramics;Dobrzański;J. Mater. Process. Technol.,2006

Cited by 36 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Effect of V concentration in TiSiN monolayer coating on chip formation mechanism and chip sliding velocity during dry turning of Ti–6Al–4V alloy;Journal of Materials Research and Technology;2024-09

2. Cutting Performance of TiN/TiSiN Coated Tool during Turning of Ti6Al4V Titanium Alloy;Journal of Materials Engineering and Performance;2024-07-17

3. Influence of V concentration in TiAlSiVN coating on self-lubrication, friction and tool wear during two-pass dry turning of austenitic steel 316 L;Tribology International;2024-05

4. Comparison of Machinability of Al-4.5%Cu/TiB2/3p MMC for Multi-Layer Coated Insert: Validated FEM and Statistical Approaches;Mühendis ve Makina;2024-04-29

5. Hard turning of AISI H10 steel using AlTiN and AlTiSiN coated carbide tools: comparative machining performance evaluation and economic assessment;Journal of the Brazilian Society of Mechanical Sciences and Engineering;2024-04-05