Evaluation of response characteristics using sensitivity analysis and TLBO technique of powder mixed wire EDM of Ti6Al4V alloy-Reference-Cited by-同舟云学术

Evaluation of response characteristics using sensitivity analysis and TLBO technique of powder mixed wire EDM of Ti6Al4V alloy

Published:2023-12 Issue: Volume:47 Page:260-272
ISSN:1755-5817
Container-title:CIRP Journal of Manufacturing Science and Technology
language:en
Short-container-title:CIRP Journal of Manufacturing Science and Technology

Author:

Chakraborty Sadananda,Mitra Souren,Bose Dipankar

Publisher

Elsevier BV

Subject

Industrial and Manufacturing Engineering

Reference36 articles.

1. Estimation of wire strength based on residual stresses induced during wire electric discharge machining;Das;J Manuf Process,2020

2. Enhancing die corner accuracy through trim cut in WEDM;Selvakumar;Int J Adv Manuf Technol,2015

3. Relationship between energy consumption and surface integrity aspects in electrical discharge machining of hot work die steel;Nieslony;Sustain Mater Technol,2023

4. Surface modification of WC-Co alloy using Al and Si powder through WEDM: A thermal erosion process;Kumar;Particulate Sci Technol,2017

5. Performance evaluation of surfactant mixed dielectric and process optimization for electrical discharge machining of titanium alloy Ti6Al4V;Asif;CIRP J Manuf Sci Technol,2023

Cited by 3 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Optimization of Kerf Width in WEDM of Sandwich Woven CFRP-An Ensemble Machine Learning Based Approach;Arabian Journal for Science and Engineering;2024-08-31

2. Comparing surface characteristics of Cu-Al-Fe alloys using thermal-based machining processes;Surface Engineering;2024-08-16

3. Surface characteristics of in-situ Al-2Mg/20 Al3Fe composite in wire-EDM: experiments, modeling and optimizations by MORSM and metaheuristic approaches;International Journal on Interactive Design and Manufacturing (IJIDeM);2024-05-24