Tailoring fiber arrangement in subsurface damage layer of unidirectional CFRP composites by reverse multi-pass cutting-Reference-Cited by-同舟云学术

Tailoring fiber arrangement in subsurface damage layer of unidirectional CFRP composites by reverse multi-pass cutting

Published:2022-08 Issue: Volume:227 Page:109571
ISSN:0266-3538
Container-title:Composites Science and Technology
language:en
Short-container-title:Composites Science and Technology

Author:

Han La,Zhang Junjie^ORCID,Sun Tao

Funder

Science Challenge Project

Publisher

Elsevier BV

Subject

General Engineering,Ceramics and Composites

Reference59 articles.

1. A review of mechanical drilling for composite laminates;Liu;Compos. Struct.,2012

2. Strain-rate and off-axis loading effects on the fibre compression strength of CFRP laminates: experiments and constitutive modelling;Thomson;Compos. Sci. Technol.,2020

3. Effect of strain rate and fibre rotation on the in-plane shear response of ±45° laminates in tension and compression tests;Cui;Compos. Sci. Technol.,2016

4. Investigation of delamination and surface quality of machined holes in drilling of multiwalled carbon nanotube doped epoxy/carbon fiber reinforced polymer nanocomposite;Kumar;Proc. Inst. Mech. Eng. Part L J. Mater. Des. Appl.,2019

5. Experimental and numerical investigations on push-out delamination in drilling of composite laminates;Higuchi;Compos. Sci. Technol.,2020

Cited by 7 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Design of a Compact 3-D Vibration-Assisted Turning Device With Large Amplitude and High Frequency for Diversified Microstructure Sculpturing;IEEE Transactions on Industrial Electronics;2024-03

2. Tensile mechanical properties and damage analysis of layered woven GFRP composite bolts;Composites Part B: Engineering;2024-02

3. A critical review of piezoelectric ultrasonic transducers for ultrasonic-assisted precision machining;Ultrasonics;2023-12

4. Effect of milling type and cooling mode on cutting characteristics during CFRP milling using a PCD burr end mill;The International Journal of Advanced Manufacturing Technology;2023-10-18

5. Fabrication of silver/silver-tetracyanoquinodimethane heterogeneous nanowires using nanoskiving method;Materials Characterization;2023-10