Deformation type during the ball milling process: A comparative study of the microstructures formed by ball milling, uniaxial compression, and rolling-Reference-Cited by-同舟云学术

Deformation type during the ball milling process: A comparative study of the microstructures formed by ball milling, uniaxial compression, and rolling

Published:2023-08 Issue: Volume:426 Page:118598
ISSN:0032-5910
Container-title:Powder Technology
language:en
Short-container-title:Powder Technology

Author:

Fujita Syunsuke,Sato Hisashi,Motozuka Satoshi

Funder

Japan Society for the Promotion of Science

Publisher

Elsevier BV

Subject

General Chemical Engineering

Reference44 articles.

1. Electromagnetic properties of flake-shaped Fe–Si alloy particles prepared by ball milling;Cao;J. Magn. Magn. Mater.,2014

2. Mechanical alloying and milling;Suryanarayana;Prog. Mater. Sci.,2001

3. The synthesis and optical properties of Al/MnO2 composite pigments by ball-milling for low infrared emissivity and low lightness;Liu;Prog. Org. Coat.,2017

4. Introduction to magnetism and magnetic materials;David,1998

5. Fundamental study on the mechanical strength of soft magnetic composite prepared by ultra-high aspect ratio flake iron powder using ball-milling process;Ohba;Powder Metall.,2022

Cited by 6 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Enhancing zero-valent iron (ZVI) pulverization during mechanical milling: FeSx as milling aids;Journal of Environmental Chemical Engineering;2024-10

2. Transformation of quinoa seeds to nanoscale flour by ball milling: Influence of ball diameter and milling time on the particle sizing, microstructure, and rheology;Journal of Food Engineering;2024-10

3. Analysis for Effects of Collision Velocity and Angle of Grinding Balls on Particle Grinding Behavior during Wet Ball Milling;Journal of the Society of Powder Technology, Japan;2024-05-10

4. Low-temperature coating of Mn2O3–MoS2 micro-nano-heterostructure anode as an efficient catalyst for water splitting applications;Journal of Materials Science;2024-04-17

5. Is It Possible to Use Breakage Models to Predict Particle Deformation?;JOM;2023-12-18