Thermal-hydraulic characteristics of pressurized water reactors during commercial operation: VII. Thermal-hydraulics of the PWR Paluel 1 steam generator during commercial operation-Reference-Cited by-同舟云学术

Thermal-hydraulic characteristics of pressurized water reactors during commercial operation: VII. Thermal-hydraulics of the PWR Paluel 1 steam generator during commercial operation

Published:1988-01 Issue:3 Volume:105 Page:285-293
ISSN:0029-5493
Container-title:Nuclear Engineering and Design
language:en
Short-container-title:Nuclear Engineering and Design

Author:

Wazzan A.R.,Procaccia H.,David J.,Fromal A,Pitner P.

Publisher

Elsevier BV

Subject

Mechanical Engineering,Waste Management and Disposal,Safety, Risk, Reliability and Quality,General Materials Science,Nuclear Energy and Engineering,Nuclear and High Energy Physics

Reference17 articles.

1. Circulation ratio and carryunder in a PWR steam generator;Wazzan,1982

2. Steady state thermal measurements on the secondary side of a PWR steam generator;Procaccia,1982

3. PWR stem generator response to a scream at 50% load and an open grid transient;dePenguern,1982

4. Tests of types 51A and 51M steam generators at Bugey 4 and Tricastin 1 nuclear power plants;Procaccia;Electric Power Research Institute Report NP-1689, Project S154-1, Final Report,1982

5. Saturation pressure, circulation ratio and carryunder in a PWR steam generator: Tricastin 1 nuclear power plant;Wazzan;Nucl. Engrg. Des.,1984

Cited by 4 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Experimental investigations of droplet carryover from the separator drum of an air-lift loop simulating a scaled-down AHWR;Experimental Thermal and Fluid Science;2012-10

2. Prediction of circulation rates in vertical tube thermosiphon reboiler;International Journal of Heat and Mass Transfer;1995-03

3. Local chemical and thermal-hydraulic analysis of U-tube steam generators;Nuclear Engineering and Design;1990-09

4. Vertical thermosyphon reboilers. Maximum heat flux and separation efficiency;Industrial & Engineering Chemistry Research;1990-07