Robust surface fitting—Using weights based on à priori knowledge about the measurement process-Reference-Cited by-同舟云学术

Robust surface fitting—Using weights based on à priori knowledge about the measurement process

Published:2009-03 Issue:5-6 Volume:266 Page:515-517
ISSN:0043-1648
Container-title:Wear
language:en
Short-container-title:Wear

Author:

Langholz Nils,Seewig Jörg,Reithmeier Eduard

Publisher

Elsevier BV

Subject

Materials Chemistry,Surfaces, Coatings and Films,Surfaces and Interfaces,Mechanics of Materials,Condensed Matter Physics

Reference5 articles.

1. A. Weidner, J. Seewig, E. Reithmeier, Structure oriented 3D Roughness evaluation with optical profilers, Proceedings of the 10th International Conference Metrology and Properties of Engineering Surfaces.

2. N. Langholz, J. Seewig, E. Reithmeier, Reconstruction of Bad Values in Optical Measured surface data, Proceedings of the 10th International Conference Metrology and Properties of Engineering Surfaces.

3. Aberrations in high aperture conventional and confocal imaging systems;Shepard;Applied Optics,1988

4. Confocal Microscopy;Wilson,1990

5. N.R. Draper, H. Smith, Applied Regression Analysis, Wiley Series in Probability and Statistics, 1998.

Cited by 5 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Effect of a Misidentified Centre of a Type ASG Material Measure on the Determined Topographic Spatial Resolution of an Optical Point Sensor;Metrology;2022-01-05

2. Problem of selection of reference plane with deep and wide valleys analysis;Journal of Physics: Conference Series;2018-08

3. Confocal signal evaluation algorithms for surface metrology: uncertainty and numerical efficiency;Applied Optics;2017-07-17

4. Technological shifts in surface metrology;CIRP Annals;2012

5. Effect of Initial Cylinder Liner Honing Surface Roughness on Aircraft Piston Engine Performances;Tribology Letters;2011-01-06