Study of forming limit curves and mechanical properties of three-layered brass (CuZn10)/ low carbon steel (St14) /brass (CuZn10) composite considering the effect of annealing temperature-Reference-Cited by-同舟云学术

Study of forming limit curves and mechanical properties of three-layered brass (CuZn10)/ low carbon steel (St14) /brass (CuZn10) composite considering the effect of annealing temperature

Published:2022-05 Issue: Volume:18 Page:4672-4682
ISSN:2238-7854
Container-title:Journal of Materials Research and Technology
language:en
Short-container-title:Journal of Materials Research and Technology

Author:

Gholami Mohammad Delshad,Davoodi Behnam,Hashemi Ramin^ORCID

Funder

Iran National Science Foundation

Publisher

Elsevier BV

Subject

Metals and Alloys,Surfaces, Coatings and Films,Biomaterials,Ceramics and Composites

Reference71 articles.

1. Mechanical behaviour of laminated metal composites;Lesuer;Int Mater Rev,1996

2. Clad metals: fabrication, properties, and applications;Cho;Met,2021

3. The deformation characteristics, fracture behavior and strengthening-toughening mechanisms of laminated metal composites: a review;Gao;Met,2019

4. Study of mechanical properties and wear resistance of Al 1050/Brass (70/30)/Al 1050 composite sheets fabricated by the accumulative roll bonding process;Gholami;J Manuf Process,2021

5. High-strength, high-conductivity ultra-fine grains commercial pure copper produced by ARB process;Hosseini;Mater Des,2009

Cited by 8 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Shear band mediated microstructure in an accumulative roll bonded α-brass alloy during strain path changes and annealing;Journal of Materials Research and Technology;2024-05

2. Study of single point incremental forming limits of Al 1050/Mg-AZ31B two-layer sheets fabricated by roll bonding technique: Finite element simulation and experiment;Journal of Materials Research and Technology;2024-03

3. The effect of cutting speed on friction, vibration, and temperature of PVD-coated carbide tools in ST 42 steel manufacturing;AIP Conference Proceedings;2024

4. An Experimental Study on the Creep Behavior of Al 1050/Mg AZ31B Bilayer Sheet Fabricated via Roll Bonding;Journal of Materials Engineering and Performance;2023-10-23

5. Investigation of microstructure evolution on the fracture toughness behaviour of brass/low carbon steel/brass clad sheets fabricated by cold roll bonding process;Journal of Materials Research and Technology;2023-07