Multi response optimization of injection moulding process to reduce sink marks and cycle time-Reference-Cited by-同舟云学术

Multi response optimization of injection moulding process to reduce sink marks and cycle time

Published:2023 Issue: Volume:72 Page:1089-1093
ISSN:2214-7853
Container-title:Materials Today: Proceedings
language:en
Short-container-title:Materials Today: Proceedings

Author:

Pachorkar Padmakar,Singh Gurjeet,Agarwal Neeraj,Srivastava Ashish

Publisher

Elsevier BV

Subject

General Medicine

Reference22 articles.

1. Optimal process design of shrinkage and sink marks in injection molding;Zhang;J. Wuhan Univ. Technol.-Mater. Sci. Ed.,2007

2. Investigation of the effect of molding variables on sink marks of plastic injection molded parts using Taguchi DOE technique;Shen;Polym.-Plast. Technol. Eng.,2007

3. Minimization of sink mark defects in injection molding process–Taguchi approach;Mathivanan;Int. J. Eng. Sci. Technol.,2010

4. Parametric optimization of plastic injection moulding for FMCG polymer moulding (PMMA) using hybrid Taguchi-WASPAS-Ant Lion optimization algorithm;Ravikiran;Mater. Today: Proc.,2021

5. G. Ramesh, M.Y. Reddy, Minimization of sink mark defects in injection moulding process, Int. J. Adv. Eng. Global Technol. I 03, 989–996.

Cited by 3 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Multi-Objective Optimization of Injection Molding Parameters for Manufacturing Thin-Walled Composite Connector Terminals;Materials;2024-08-08

2. Optimization Techniques in Compression Moulding: A Comprehensive Review;Materials Science Forum;2024-02-08

3. Optimizing the Injection Molding Parameters of Mask Waste Recycling into Door Knob Products;E3S Web of Conferences;2023