Ingenious analysis on machining parameters of aluminium alloy (LM25)/graphite (Gr)/ boron carbide (B4C) hybrid composites using wire electrical discharge machining (WEDM)-Reference-Cited by-同舟云学术

Ingenious analysis on machining parameters of aluminium alloy (LM25)/graphite (Gr)/ boron carbide (B4C) hybrid composites using wire electrical discharge machining (WEDM)

Published:2021 Issue: Volume:37 Page:3112-3117
ISSN:2214-7853
Container-title:Materials Today: Proceedings
language:en
Short-container-title:Materials Today: Proceedings

Author:

Suresh V.,Praneet A. Daniel,Anoop J.

Publisher

Elsevier BV

Subject

General Medicine

Reference27 articles.

1. EDM of hybrid Al–SiCp–B4Cp and Al–SiCp–Glassp MMCs;Ahamed;Int. J. Adv. Manuf. Technol.,2009

2. Investigation of wire electrical discharge machining of ZrSiO4p/Al 6063 MMC;Anand;Int. J. Mach. Mach. Mater.,2016

3. Influence of atmosphere and carbon contamination on activated pressureless infiltration of alumina–steel composites;Bahraini;Compos. A Appl. Sci. Manuf.,2010

4. Study on mechanical and wear properties of Al 7075/Al2O3/graphite hybrid composites;Baradeswaran;Compos. B Eng.,2014

5. About the epitaxial growth of Mg subgrains on Al2MgC2 interfacial carbides in a squeeze cast Mg-4Al/T300 metal matrix composite;Cayron;J. Mater. Sci. Lett.,1999

Cited by 8 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Experimental research on wire electrical discharge machining on novel hybrid composites made of Al7075/5%B4C+2%Mg and comparison with Al7075 alloy on machining timing;AIP Conference Proceedings;2024

2. Wire electrical discharge machining characteristics of rare earth oxides reinforced AZ91D magnesium alloy hybrid composite using Taguchi-grey relational analysis approach;Hybrid Advances;2023-12

3. Correlation of Structural and Mechanical Properties for Ultrasonically Stir Casted Al6061 Reinforced SiC-AlN Hybrid Metal Matrix Composites;ECS Journal of Solid State Science and Technology;2023-05-01

4. Examining the surface roughness and kerf quality of micro-slots cut on the surfaces of Ti-B₄C nanocomposites by WEDM: a desirability approach;Materials Research Express;2022-12-01

5. Impact of AlN-SiC Nanoparticle Reinforcement on the Mechanical Behavior of Al 6061-Based Hybrid Composite Developed by the Stir Casting Route;Advances in Materials Science and Engineering;2022-08-25