Influence of preform preheating on dry sliding wear behavior of 304 stainless steel reinforced A356 aluminum matrix composite produced by melt infiltration casting-Reference-Cited by-同舟云学术

Influence of preform preheating on dry sliding wear behavior of 304 stainless steel reinforced A356 aluminum matrix composite produced by melt infiltration casting

Published:2017-11 Issue: Volume:115 Page:608-618
ISSN:0301-679X
Container-title:Tribology International
language:en
Short-container-title:Tribology International

Author:

Gecu Ridvan,Atapek Ş. Hakan,Karaaslan Ahmet

Publisher

Elsevier BV

Subject

Surfaces, Coatings and Films,Surfaces and Interfaces,Mechanical Engineering,Mechanics of Materials

Reference28 articles.

1. Effect of grit size on two body abrasive wear of Al 6082 hybrid composites produced by stir casting method;Kaushik;Tribol Int,2016

2. Wettability of carbon by aluminum and aluminum alloys;Landry;Mater Sci Eng A,1998

3. Heat treatment optimization for tensile properties of 8011 Al/15% SiCp metal matrix composite using response surface methodology;Vembu;Def Technol,2015

4. Effect of reinforcement concentration on the properties of hot extruded Al-Al2O3 composites synthesized through microwave sintering process;Reddy;Mater Sci Eng A,2017

5. Dry sliding wear behaviour of AlSi-CNTs-SiCp hybrid composites;Carvalho;Tribol Int,2015

Cited by 30 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Adaptive control of filler wire speed in wire arc additive manufacturing: impact of inter-layer dwell time on metallurgical and mechanical aspects of ER70S-6 deposits;The International Journal of Advanced Manufacturing Technology;2024-06-21

2. Recent advances in wear-resistant steel matrix composites: A review of reinforcement particle selection and preparation processes;Journal of Materials Research and Technology;2024-03

3. Microstructure, strength, and fiber texture evolutions in arc-based casting using low-carbon steel wire;Journal of Manufacturing Processes;2023-09

4. Fabrication of aluminum metal matrix composite through continuous casting route: A review and future directions;Journal of Manufacturing Processes;2023-06

5. Effect of travel speed and number of layers on surface waviness of ER70S6 deposits fabricated through non-transferred wire arc additive manufacturing;Journal of Adhesion Science and Technology;2023-05-27