Author:
Niknam Seyed Ali,Songmene Victor
Reference27 articles.
1. Olvera O, G. Barrow. An experimental study of burr formation in square shoulder face milling. Int J Mach Tool Manu 1996; 36:9,p. 1005-1020.
2. Olvera O, G. Barrow. Influence of exit angle and tool nose geometry on burr formation in face milling operations. I Mech Eng B-J Eng 1998; 212:1,p. 59-72.
3. Tsann-Rong L. Experimental study of burr formation and tool chipping in the face milling of stainless steel. J Mat Proc Tech 2000; 108:1,p.12-20.
4. Avila MC, Dornfeld DA. On The Face Milling Burr Formation Mechanisms and Minimization Strategies at High Tool Engagement.P Intl Conf on Deburring and Edge Finishing, UC Berkeley 2004;191-200.
5. Korkut I, Donertas M. The influence of feed rate and cutting speed on the cutting forces, surface roughness and tool-chip contact length during face milling. Int J Mat & des 2007; 28:1,p. 308-312.
Cited by
14 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献