1. Kim J. Optimization and Control of Drilling Burr Formation in Metals. Ph.D. Dissertation. Department of Mechanical Engineering, University of California at Berkeley, 2000.
2. Deburring and edge finishing handbook;Gillespie,1999
3. Gillespie LK. The formation and properties of machining burrs. M.S. Thesis, Utah State University, Logan, UT, 1973.
4. Effect of in-plane exit angle and rake angles on burr height and thickness in face milling operation;Hashimura;J Manuf Sci Eng,1999
5. An experimental study on burr formation in micro-milling aluminum and copper;Lee;Trans North Am Manuf Res Inst,2002