The effect of SiC powder mixing electrical discharge machining on white layer thickness, heat flux and fatigue life of AISI D2 die steel-Reference-Cited by-同舟云学术

The effect of SiC powder mixing electrical discharge machining on white layer thickness, heat flux and fatigue life of AISI D2 die steel

Published:2016-09 Issue:3 Volume:19 Page:1400-1415
ISSN:2215-0986
Container-title:Engineering Science and Technology, an International Journal
language:en
Short-container-title:Engineering Science and Technology, an International Journal

Author:

Al-Khazraji Ahmed,Amin Samir Ali,Ali Saad Mahmood

Publisher

Elsevier BV

Subject

Metals and Alloys,Computer Networks and Communications,Fluid Flow and Transfer Processes,Hardware and Architecture,Mechanical Engineering,Biomaterials,Civil and Structural Engineering,Electronic, Optical and Magnetic Materials

Reference29 articles.

1. The influence of EDM parameters in finishing stage on surface quality, MRR and EWR;Atefi;Res. J. Appl. Sci. Eng. Technol,2012

2. Analysis of surface characteristics of AISI D2 tool steel material using Electric Discharge Machining process with Single wall carbon nano tubes;Prabhu;Int. J. Eng. Technol,2010

3. Investigation and modeling of silicon powder mixed EDM using response surface method;Khundrakpam;Int. J. Curr. Eng. Technol,2014

4. Improving EDM efficiency with silicon carbide powder-mixed dielectric fluid;Razak;Int. J. Mater. Mech. Manuf,2015

5. Experimental investigation on process performance of powder mixed electric discharge machining of AISI D3 steel and EN-31 steel;Reddy;Int. J. Curr. Eng. Technol,2014

Cited by 63 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Enhancing machining efficiency in hybrid metal matrix composites through EDM parameter optimization via grey relational analysis;Engineering Research Express;2024-08-01

2. IMPROVEMENT IN THE RECAST LAYER THICKNESS, CORNER RADIUS AND SURFACE ROUGHNESS OF MONEL K 400 THROUGH CFRP, NANO-SiC, AND ZrSiO₄ PARTICLES ADDED WIRE EDM;Surface Review and Letters;2024-07-12

3. Machining Performance Analysis of Ti6-Al-4V in Powder-Mixed EDM Using Green Dielectric Oil;Journal of Molecular and Engineering Materials;2024-05-06

4. Investigations on the relationship between surface roughness and process variables of die sinking electro-discharge machining;Innovation and Emerging Technologies;2024-01

5. Study on Near-Dry EDM Performance Characteristics of MSGNP/Al-7075 Using Air, Argon, Nitrogen, and Freon Dielectric Medium;Advances in Science and Technology Research Journal;2023-12-01