Apparent electrical conductivity (ECa) as a surrogate for neutron probe counts to measure soil moisture content in heavy clay soils (Vertosols)

Abstract

Site-specific measurements of the apparent electrical conductivity (ECa) of soil using the EM38 were correlated with near-simultaneous neutron probe readings over periods of moisture extraction by an irrigated cotton crop. Thirty sites were monitored from three ECa zones within a 96-ha field of grey Vertosol soil 30 km west of Moree, New South Wales, Australia. This study differs from previous approaches by reporting the effect on ECa of a wetting front (irrigation) reaching a single ECa measurement point in a field and by using polyethylene neutron probe access tubes so that the EM38 could be operated directly over the same site measured by a neutron probe. We report strong correlations (r = 0.94) between neutron probe counts (CRR) averaged to a depth of 40 or 60 cm and ECa from an EM38 held in the vertical mode 20 cm above the soil surface. All combinations of EM sensor height (0–1.2 m) to neutron probe measurement depth (0.2–1.4 m) returned correlations >0.85. The relationship between CCR and ECa was linear for the purposes of estimating water content over a range of background ECa levels. More critical modelling suggested a slight curve (logarithmic model) fitted best. The range of surface-surveyed ECa from the start of irrigation (refill point) to fully irrigated (full point) was ~27 mS m–1 for this Vertosol, where surface ECa readings typically ranged from 50 to 200 mS m–1. We suggest that the calibration of ECa to CRR might be effected by a two-point measurement of the soil, namely at both upper (field capacity) and lower (wilting point) ECa values, and a site-specific calibration template generated by extending these point measures to whole-field surveys.