Modeling of load carrying capacity and durability of metal-polymer spur gears made of polyamide RA6 based compositions-Reference-Cited by-同舟云学术

Modeling of load carrying capacity and durability of metal-polymer spur gears made of polyamide RA6 based compositions

Published:2022 Issue:2 Volume:50 Page:55-63
ISSN:1451-2092
Container-title:FME Transactions
language:en
Short-container-title:FME Transactions

Author:

Chernets M.,Kornienko A.,Dukhota A.,Chernets Yu.

Abstract

Based on the author's method of calculation of metal-polymer (MP) gears, the study of load carrying capacity and durability of metal-polymer spur gears with a gear made of unfilled polyamides PA6, PA66, and polyamide PA6 based composites filled with glass (PA6 + 30GF) or carbon (PA6 + 30CF) fibers, molybdenum disulfide (PA6 + MoS2) oil-filled cast polyamide (PA6 + Oil) is performed. The conditions of the teeth engagement and the change of the radiuses of curvature of the involute profile during wear are taken into account. The calculation of the maximum contact pressures during the cycle of teeth interaction - from the entrance to the engagement to the exit from it is performed. The effect of tooth wear on their reduction is also studied. The linear wear of polymer teeth at the selected points of a profile and the characteristic point where the acceptable value is reached (at two-pair or one-pair engagement) is established. The gear's durability is calculated and their comparative estimation is given. Qualitative and quantitative regularities of change of the specified service characteristics of MP gears at the achievement of the acceptable wear of polymeric gear teeth are established.

Publisher

Centre for Evaluation in Education and Science (CEON/CEES)

Subject

Mechanical Engineering,Mechanics of Materials

Link

https://scindeks-clanci.ceon.rs/data/pdf/1451-2092/2022/1451-20922201055C.pdf

Reference28 articles.

1. Shilko, S.V. and Starzhinsky, V.E.: Calculation of wear resistance of a gears with wheels made of reinforced composite materials, Friction and wear, Vol. 13, No. 3, pp. 444-451, 1993.;

2. Drozdov, Yu.N.: On the development of a method for calculating wear and modeling of friction. Nauka, Moscow, 1975.;

3. Hooke, C.J., Kukureka, S.N., Liao, P., Rao, M. and Chen, Y.K.: The Friction and Wear of Polymers in Non-Conformal Contacts, Wear, Vol. 200, pp. 83-94, 1996. doi: 10.1016/S0043-1648(96)07270-5;

4. Kalacska, G., Kozma, M., De Baets, P., Keresztes, R. and Zsidai, L.: Friction and wear of engineering polymer gears, in: Proc. World Tribology Congress III, September, 2005, Washington, pp. 12-16. doi: 10.1115/WTC2005-63961;

5. Keresztes, R. and Kalacska, G.: Friction of polymer/steel gear pairs, Plastics and Rubber, 45, 236-242, 2008.;