YATAĞAN-MUĞLA TÜRKİYE’ DE KURULU OLAN 1 MW ŞEBEKE BAĞLANTILI BİR PV GÜÇ SANTRALİNDE MATLAB-SIMULINK PORTALINDA STATCOM YOLUYLA PERFORMANS İYİLEŞTİRİLMESİ-Reference-Cited by-同舟云学术

YATAĞAN-MUĞLA TÜRKİYE’ DE KURULU OLAN 1 MW ŞEBEKE BAĞLANTILI BİR PV GÜÇ SANTRALİNDE MATLAB-SIMULINK PORTALINDA STATCOM YOLUYLA PERFORMANS İYİLEŞTİRİLMESİ

Published:2023-03-27 Issue:1 Volume:11 Page:113-125
ISSN:1308-6693
Container-title:Mühendislik Bilimleri ve Tasarım Dergisi
language:
Short-container-title:

Author:

KALAY Altan¹^ORCID,AĞÇAL Ali²^ORCID,ULGEN Koray³^ORCID

Affiliation:

1. MUGLA SITKI KOCMAN UNIVERSITY, YATAĞAN VOCATIONAL SCHOOL, DEPARTMENT OF ELECTRICITY AND ENERGY, ELECTRIC PR.

2. SULEYMAN DEMIREL UNIVERSITY

3. EGE UNIVERSITY, INSTITUTE OF SOLAR ENERGY, DEPARTMENT OF SOLAR ENERGY

Abstract

A grid-connected power system's performance depends on the produced energy's power quality and power coefficient. The higher the power quality of the energy transferred to the grid, the more critical it is for power plants, energy distribution systems and end-users. This study investigated the optimisation possibilities obtained by applying STATCOM (Static VAR Compensation) for a 1 MW PV-based Solar Power Plant (PV-SPP) in the Muğla-Türkiye province. First, the data of components such as the inverter and PV panel that make up the plant were obtained, and the raw MATLAB-Simulink modelling of the plant was carried out. System performance outputs were obtained by adding STATCOM modelling to the obtained modelling. The scientific results of the optimisation would be obtained if this technique was applied to the existing power plant. Since STATCOM also performs the RPC (Reactive Power Compensation) process, it is an up-to-date and effective technique that improves system energy power quality. According to the simulation results, this system with STATCOM draws 24,043% and 11,671% less reactive power and current than the non-STATCOM system.

Publisher

Muhendislik Bilimleri ve Tasarim Dergisi

Subject

Colloid and Surface Chemistry,Physical and Theoretical Chemistry

Reference20 articles.

1. Tobnaghi D.M., 2016, A Review on impacts of Grid-connected PV system on Distribution Networks. International Journal of Electrical and Computer Engineering 10(1): 137-152.

2. Priyadarshi N., Anand A., Sharma A., Azam F., Singh V., Sinha R., 2017, "An experimental implementation and testing of GA based maximum power point tracking for PV system under varying ambient conditions using dSPACE DS 1104 controller." International Journal of Renewable Energy Research (IJRER) 7.1, pp. 255-265.

3. Nishioka K., Hatayama T., Uraoka Y., Fuyuki T., Hagihara R., Watanabe M., 2003, Field-test analysis of PV system output characteristics focusing on module temperature. Solar Energy Materials and Solar Cells; 75(3–4): 665-671.

4. Kameda M., Sakai S., Isomura M., Sayama K., Hishikawa Y., Matsumi S., Haku H., Wakisaka K., Tanaka M., Kiyama S., Tsuda S., Nakano S., 1996, "Efficiency evaluation of a-Si and c-Si solar cells for outdoor use," Conference Record of the Twenty-Fifth IEEE Photovoltaic Specialists Conference-pp. 1049-1052. DOI: 10.1109/PVSC.1996.564310.

5. Sewang Y. and Garboushian V., 1994; Reduced temperature dependence of high-concentration photovoltaic solar cell open-circuit voltage (Voc) at high concentration levels. In: Proceedings of 1994 IEEE 1st World Conference on Photovoltaic Energy Conversion - WCPEC (A Joint Conference of PVSC, PVSEC and PSEC); IEEE: pp.1500-1504.