Analysis and Optimization of Shielded Metal Arc Welding Parameters on Mechanical Properties of Dissimilar Materials-Reference-Cited by-同舟云学术

Analysis and Optimization of Shielded Metal Arc Welding Parameters on Mechanical Properties of Dissimilar Materials

Published:2023-06-10 Issue: Volume: Page:672-679
ISSN:2394-4099
Container-title:International Journal of Scientific Research in Science, Engineering and Technology
language:en
Short-container-title:IJSRSET

Author:

Sanjay Singh ¹,Dr. Sanjay Kumar Gupta ²

Affiliation:

1. M.Tech Scholar, Production Engineering, Research Scholar, Department of Mechanical Engineering Maharshi University of Information Technology, Lucknow, Uttar Pradesh, India

2. Assistant Professor, Department of Mechanical Engineering, Maharshi University of Information Technology, Lucknow, Uttar Pradesh, India

Abstract

Shielded metal arc welding is the most efficient and economical process through which it can easily weld. Residual stress is prompt in the welding process. In, some of cases, there is entrapment and deformation that can endanger the coherence of welding properties. So, the mechanical properties of welded joints can be changed accordingly to the heat-affected zone. In this study, the joint between two dissimilar AISI304 steel and Mild steel having a thickness of 5mm which is welded through a shielded metal arc welding (SMAW) in the V-groove shaped has been produced. In this research, we examines the mechanical properties of the material and their experimental and numerical analysis can also be measured through the Ultimate Tensile test, which introduces the entrapment and distortion of the finite element. It mainly focusses on final outcomes of the accuracy and strength of the material has been investigated.

Publisher

Technoscience Academy

Subject

General Medicine

Reference14 articles.

1. Lee, W.-S., Cheng, J.-I., & Lin, C.-F. (2004). Deformation and failure response of 304L stainless steel SMAW joint under dynamic shear loading. Materials Science and Engineering: A, 381(1-2), 206–215.

2. R. Sathish, B. Naveen, P. Nijanthan, K. Arun Vasantha Geethan, Vaddi Seshagiri Rao, Weldability and process parameter optimization of dissimilar pipe joints. International Journal of Engineering Research and Applications, Vol.2,Issue 3,pp- 2525- 2530,2012.

3. Tarang, Y.S. and W.H.,Yang, 1998. “Optimization of weld bead geometry in GTAW by Taguchi method”, Int J Adv Manuf Technol, Vol. 14, pp.549 – 554.

4. S.P.Gadewar, Peravli Swaminadhan, M.G.Harkare, S.H.Gawande, 2010. “Experimental investigation of weld characteristics for a single pass TIG welding with SS304”, International Journal of Engineering Science and Technology, Vol. 2(8), 3676-3686.

5. Y.S. Tarng, W.H. Yang, S.C. Juang, “ The use of fuzzy logic in the Taguchi Method for the optimisation of the submerged arc welding Process”, Int. J. Adv. Manuf. Technol. 16 (2000) 688–694.