SUPERIORITY OF ARTIFICIAL NEURAL NETWORKS OVER STATISTICAL METHODS IN PREDICTION OF THE OPTIMAL LENGTH OF ROCK BOLTS

Abstract

Rock bolting is one of the most important support systems used for rock structures. Rock bolts are widely used in underground excavations as they are suitable for a wide range of geological conditions and allow using progressive design methods; besides, they help economising in the use of materials and manpower. Thus, to provide the most effective support at minimum cost by means of rock bolting, it is essential to optimise the elements contributing to bolt design, including their length, as well as bolt density and tension during installation. This paper considers the length of bolts for optimisation of the design phase, which is one of the most important parameters impacting the entire design procedure. Presenting and comparing results of some statistical models, neural network modeling is introduced as powerful means in prediction of the optimal length of rock bolts. Subsequent to training and testing of a large number of 1-layer and 2-layer backpropagation neural networks, it was reported that the optimal model was the network with the architecture of 6-18-3-1 as it demonstrated the minimum RMSE and MAE as well as the maximum R2. In comparison to statistical models (0.7182 for the value of R2 in the multiple linear regression model, 0.68 in the polynomial model and 0.7 in the dimensionless model), the results obtained by the neural network modeling – i.e. the coefficient of determination R2 of 0.9259, the value of mean absolute error MAE of 0.068, and the root mean squared error RMSE of 0.078 – not only proved their superiority but also introduced the neural network modelling as a highly capable prediction tool in forecasting the optimal length of rock bolts. Furthermore, sensitivity analysis was used to obtain parameters that have the greatest and the least impact on the optimal bolt length: the effect of the overburden thickness, tensile strength, cohesion and Poisson's ratio on the optimal bolt length was almost the same while the friction angle had the least influence.