Effect of plasma spraying technological modes on the formation of protective and functional coatings-Reference-Cited by-同舟云学术

Effect of plasma spraying technological modes on the formation of protective and functional coatings

Published:2023-11-30 Issue:7 Volume: Page:33-37
ISSN:1683-4518
Container-title:NOVYE OGNEUPORY (NEW REFRACTORIES)
language:
Short-container-title:Nov. ogneup.

Author:

Kravchenko I. N.,Zhachkin S. Yu.,Timashov E. P.,Trifonov G. I.,Kartsev S. V.,Kuznetsov S. N.

Abstract

The improvement of the technology of plasma deposition of wear-resistant coatings is shown. At the same time, special attention is paid to one of the most important parameters ― the thickness of the functional layer, since when using plasma deposition methods, it has a significant impact on the quality of coatings, as well as the functionality and productivity of the process. Based on the planning of the experiment, mathematical models have been developed that make it possible to establish the relationship between the coating thickness and the given technological parameters of the plasma spraying process. The results of the analysis of the dependences obtained showed that the thickness of the coating is most affected by the strength of the arc current of the plasma torch.

Publisher

National University of Science and Technology MISiS

Subject

Computer Networks and Communications,Hardware and Architecture,Software

Reference22 articles.

1. Bespalov, V. V. Tekhnologicheskoe obespechenie kachestva mashin / V. V. Bespalov // Tr. Nizhegorod. gos. tekhn. un-ta im. R. E. Alekseeva. ― 2014. ― № 5 (107). ― S. 334‒338.

2. Ivanov, A. Yu. Tekhnologicheskie metody obespecheniya kachestva izdelii / A. Yu. Ivanov, D. B. Leonov // Nauchno-tekhn. vestnik Sankt-Peterburg. gos. un-ta informatsionnykh tekhnologii, mekhaniki i optiki. ― 2011. ― № 5 (75). ― S. 111―114.

3. Kogan, B. I. Novye printsipy tekhnologicheskogo obespecheniya kachestva remonta mashin / B. I. Kogan, M. A. Shikolovich, M. A. Berezinskii // Vestnik Kuzbas. gos. tekhn. un-ta. ― 2006. ― № 3 (54). ― S. 72‒75.

4. Moskvitin, G. V. Sovremennye uprochnyayushchie pokrytiya kriticheskikh detalei mekhanizmov i instrumenta / G. V. Moskvitin, E. M. Birger, A. N. Polyakov, G. N. Polyakova // Metalloobrabotka. ― 2015. ― № 2. ― S. 22‒27.

5. Pilyushina, G. A. Perspektivnye puti povysheniya iznosostoikosti detalei mashin i oborudovaniya / G. A. Pilyushina // Novye materialy i tekhnologii v mashinostroenii. ― 2015. ― № 21. ― S. 56‒59.