Affiliation:
1. Liaoning Petrochemical University
Abstract
Abstract
The high milling temperature in the high-speed milling process restricts the production efficiency and processing quality of titanium alloy thin-walled parts. Optimizing the processing parameters can control the temperature within a reasonable range, which can improve its production efficiency and processing quality. Therefore, it is imperative to conduct research on milling temperature and multi-objective parameter optimization during the milling process. In this paper, the temperature field model of the workpiece was established using the moving heat source method. The finite element method was used to simulate the temperature field of the workpiece during the milling process. The milling temperature was measured by an infrared thermal imager, and a milling temperature prediction model was set up based on the experimental data. Considering the minimum milling temperature and the maximum material removal rate, the whale optimization algorithm (WOA) was applied to optimize the processing parameters. The results showed that the maximum error of simulation and experimental results is less than 16%. The optimization method can provide reference for the selection of subsequent milling parameters.
Publisher
Research Square Platform LLC
Reference22 articles.
1. Mruthunjaya M, Yogesha KB (2021) A review on conventional and thermal assisted machining of titanium based alloy, Materials Today: Proceedings, 46: 8466–8472
2. A novel analytical algorithm for prediction of workpiece temperature in end milling;Akhtar W;CIRP Ann,2022
3. Analytical prediction of cutting tool temperature distribution in orthogonal cutting including third deformation zone;Barzegar Z;J Manuf Process,2021
4. Modelling and Prediction of Cutting Temperature in the Machining of H13 Hard Steel of Transient Heat Conduction;Jingjie Z
5. Analytical modeling and experimental investigation of tool and workpiece temperatures for interrupted cutting 1045 steel by inverse heat conduction method;Jiang F;J Mater Process Technol,2013