Influence of different skew angles of the submerged vane on pressure flushing performance

Abstract

Abstract Siltation is a major threat to the original storage capacity and lifespan of a reservoir. Pressure flushing is an effective measure against siltation through the partial drawdown of the reservoir water level with limited flushed cone volumes in front of the bottom outlet. In this study, a novel configuration with submerged vanes has been proposed and tested experimentally to increase the flushed sediment volume during the pressure flushing operation. In the new configuration, submerged vanes aligned with ten skew angles (θ) of 10°, 20°, 30°, 45°, 70°, 110°, 135°, 150°, 160°, and 170° to flow direction in non-cohesive sediment bed materials were conducted. The results showed that in 45° ≤ θ ≤ 160°, increasing the skew angle increased the flushing cone geometry. The minimum and maximum flushing cone dimensions and volume occurred at skew angles of θ = 45° and 135° ≤ θ ≤ 160° around the bottom outlet. Eventually, nonlinear regression analysis yielded an equation for estimating flushing cone volumes. The developed equation was tested in real case studies of a target reservoir, and an acceptable correlation between calculated and experimental results was obtained.