Affiliation:
1. School of Mechanical Engineering
Abstract
Abstract
There are inequable force-induced deformation, obvious cutting vibration problems during side milling of low-rigidity frame and beam parts, resulting in unsatisfactory dimensional accuracy and surface quality. Most of these parts are side-milled by end mill, which currently in use do not take into account the workpiece stiffness imparity. Therefore, the concept of Gradient Helix Edge (GHE) is proposed in this research and its advantages are analyzed. The general mathematical model is given. And the parabola is taken as an example for the GHE space equation derived, of which accuracy is verified by numerical simulation. Finally, The comparison experiment with the invariant helix edge end mill was completed. The results showed that the milling force perpendicular to the milling surface of the GHE end mill was smaller and less fluctuation, which could obtain less force-induced deformation theoretically. The milling process was smoother, and better surface quality was obtained. The excellent performance of the GHE end mill was further verified by milling different features.
Publisher
Research Square Platform LLC
Reference21 articles.
1. Tool life cycle intelligent control technology for intelligent manufacturing;Liu XL;Chin J Mech Eng,2021
2. State of the art in milling process of the flexible workpiece;Fei JX;Int J Adv Manuf Technol,2020
3. LH(2021)Research progress on machining deformation of thin-walled parts in milling process;Yue CX
4. J(2018)Investigation of moving fixture on deformation suppression during milling process of thin-walled structure[J];Fei JX
5. WH(2021)Mitigation of chatter in thin-wall milling by using double-sidesupport devic;Yuan H