Affiliation:
1. LEM3: Laboratoire d'Etude des Microstructures et de Mecanique des Materiaux
Abstract
Abstract
Micro-cutting is characterised by undeformed chip thicknesses in the micron range. This range leaves little choice of in situ observation techniques. One solution is therefore to observe these zones a posteriori after the cutting has been abruptly interrupted. This technique has proven to be very useful for conventional machining. This paper deals with the development of a quick-stop device dedicated to micro-cutting. The aim of this device is to observe cutting mechanisms and chip formation at this scale.
Publisher
Research Square Platform LLC
Reference11 articles.
1. Subbiah, Sathyan and Melkote, Shreyes N (2008) Effect of finite edge radius on ductile fracture ahead of the cutting tool edge in micro-cutting of Al2024-T3. Materials Science and Engineering: A 474(1-2): 283--300 https://doi.org/10.1016/j.msea.2007.04.116, Elsevier
2. Satheesha, M and Jain, VK and Kumar, P (1990) Design and development of a quick-stop device (QSD). Precision engineering 12(4): 205--212 https://doi.org/10.1016/0141-6359(90)90062-4, Elsevier
3. Ellis, J and Kirk, R and Barrow, G (1969) The development of a quick-stop device for metal cutting research. International Journal of Machine Tool Design and Research 9(3): 321--339 https://doi.org/10.1016/0020-7357(69)90007-9, Elsevier
4. Rebaioli, Lara (2012) Design and characterization of a new quick-stop device for micromachining. Italy
5. Schneider, F and Bohley, M and Lohkamp, R and Sousa, FJP and M{\"u}ller, R and Aurich, JC Development of a Quick-Stop-Device to investigate chip formation in micro-and nanomachining.